Reinforcing Plate for a Thule Adventurer Cargo Box

Question

Question:

Is it possible to order just one Reinforcing plate TH10378?

asked by: Chris T

0

Expert Reply:

The Reinforcing Plate, part # TH10378 comes as a 1 piece pack, so you can order just one of them for a quick fix.

expert reply by: Jacob W

0

Answer 1

In order to mount your Yakima Space Cadet Cargo Box to the roof of your 2008 Honda Odyssey you will indeed need to add crossbars. For your Odyssey that features the factory raised side rails I recommend the Yakima CoreBar System. This roof rack…

view full answer...

Answer 2

The Replacement Plate Box Support for Adventurer Cargo Box, #TH10378, is the rectangular flat plate. We do offer a complete kit, #TH04997, that comes with all the necessary Thule QM3 hardware for the Adventurer cargo box. This kit comes with the…

view full answer...

Answer 3

The U-bolt of the Replacement U-Bolt Assembly #Y27CR is 4.5 inches from each leg on center.

view full answer...

Answer 4

The Replacement Plate Box Support for Adventurer Cargo Box #TH10378 is 5-1/2 inches long and 2-1/2 inches wide with holes that are 5/16 inch diameter 4 inches on center. I've attached a photo to help further.

view full answer...

Answer 5

I can help you. I have included a picture that shows how that type of Yakima hardware goes together. With that image you should have no trouble getting everything together in the right order.

view full answer...

Answer 6

Yes, technically you can remove the lid of this Yakima RocketBox Pro 14 Rooftop Cargo Box 14ft, part #Y07192, but I do not recommend it. The box has a simple ball and socket joint that you will have to disengage to remove the lid. Once the lid has…

view full answer...

Answer 7

I have the perfect solution for you. The Hollywood Racks Sport Rider SE2 Platform 2 Bike Rack w/Cargo Carrier #HR1450Z-85 is a 2 bike platform rack with a cargo carrier that attaches to the rear of it. I attached a picture of what it looks like as…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Reinforcing Plate for a Thule Adventurer Cargo Box

Product Page this Question was Asked From

Continue Researching