Recommended Truck Bed Camper Jack for 2011 Ram

Question

Question:

need to know the jack for a 2011 ram.

asked by: Arthur

0

Expert Reply:

If you are looking for truck bed camper jacks for your 2011 Ram, I recommend looking at the Brophy Cable Camper Jacks # CJ74. These will allow you to easily load or unload your truck camper with just a pair of portable jack assemblies. They have a lifting range of 17 to 67 inches and a combined weight capacity of 3,000 pounds. The overall height when assembled is 76 inches.

I have attached a link that will take you to our available selection of truck camper jacks that you can also look through.

expert reply by: Chris R

0

Answer 1

The Brophy Cable Camper Jacks - 67" Max Lift Height - 3,000 lbs - Qty 2 #CJ74 don't really stick out . They hold the camper pretty much flush with the edge of the camper. I went into our warehouse to measure for you and the 2x2 inch l…

view full answer...

Answer 2

The L-Bracket on the Brophy Cable Camper Jacks #CJ74 would need to slide under your camper shell on either side and then you would use the winches to help raise the camper shell off of your Ford F-350. You can use 2x4s if you want to but really the…

view full answer...

Answer 3

We don't currently have any customer submitted photos for the Brophy Heavy Duty Cable Camper Jacks #CX74, but we do for the lower capacity #CJ74, which uses the same lift brackets. From the edge of the tube to the lift bracket is approximately…

view full answer...

Answer 4

Yes, technically the camper needs to hang over truck bed rails for the Brophy Heavy Duty Cable Camper Jacks - 67" Max Lift Height - 4,000 lbs #CX74 to get under the camper and lift it up properly. This should be self-explanatory, but if the…

view full answer...

Answer 5

Yes, Jeff, your 2024 Tacoma TRD is a great match, as is any vehicle with a 7 way connector on the back. You’ll just want to use the Redarc #RED57AR and you won't need anything else. It connects in front of the 7 way outlet on your vehicle, then…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Recommended Truck Bed Camper Jack for 2011 Ram

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching