Replacement Ladder for a 2004 Monaco Dynasty

Question

Question:

My ladder on my coach the support brackets are becoming rusty and I think I need a new ladder. The original is made by Christianson. Do you carry this

asked by: CHuck G

0

Expert Reply:

I may have an alternative solution for you, but we do not carry any ladders made by Christianson.

We do carry the Stromberg Carlson RV Exterior Ladder w/ Hinges, part # LA-401 for Silver or part # LA-401BA for Black, which is a universal fit ladder. It is 99-1/2" tall x 12 " wide but has a customizable height - you just need to trim the length of the ladder to fit your application using a hacksaw or tube cutter.

I have attached a picture giving the dimensions of the ladder as well as a review video for you to check out.

expert reply by: Jon G

0

click to enlarge

Answer 1

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 2

The Trailer Hub and Drum Assembly part #AKHD-545-35-K is the correct replacement for an AL-KO 7230. In regards to the braking assemblies, I suggest getting a new pair, the Electric Trailer Brake Kit part #AKEBRK-35-SA. This option will save you some…

view full answer...

Answer 3

For your AL-KO 7230, the replacement wheel stud you most likely need is the 1/2" Diameter x 2" Long - Qty 1 #7-122. This is the replacement for the Dexter Hub that replaced the AL-KO hub when Dexter bought them out. This should work well on…

view full answer...

Answer 4

We offer replacement brake shoes for 10 x 1-1/2- and 10 x 2-1/4-inch electric drum brakes but no longer for the 1-3/4-inch width you reference. Dexter part #bp04-065 you referenced is a set of replacement brake shoes for electric trailer brakes…

view full answer...

Answer 5

This could be a magnet wiring problem. It is unlikely that the magnets are bad on newer assemblies, but if the wiring is not properly connected, it could cause problems. Check to see that the magnets are properly grounded to a clean, bare metal…

view full answer...

Answer 6

By Two Part Ladder, do you mean that there's a hinge on your existing ladder? If so, your choice would be between the Stromberg Carlson #LA-401 and the Surco #SP501L. The Stromberg Carlson ladder is 99-1/2 inches tall, while the Surco model is 97…

view full answer...

Answer 7

In 2007, Chevrolet stopped offering plug-in connectors for brake controllers on their full size trucks with tow packages. Instead, you will have four or five blunt-cut wires bundled underneath your dash. The wire colors should be red with a black…

view full answer...

Answer 8

You are right about the look of the #JWM60A, though the reason we recommend it as a replacement for the AWM968 is that it is the model that technically replaced the AWM968 when it was discontinued in 2017. Having said that, there is an option, that…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Replacement Ladder for a 2004 Monaco Dynasty

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching