Fit and Compatibility of Weight Distribution System Chain Lift Brackets

Question

Question:

i bought two lift brackets from you guys last fall,the hooks where you hook the chains are too big to fit my chains...are there two different size hooks or are the chains on my bars the wrong size? i bought the hitch and bars from an individual ...had to put two shackles in the chain sets toi be able to use them.

asked by: Tommie M

0

Expert Reply:

There are different brackets, like the Replacement Heavy Duty Snap-Up Bracket for Reese Weight Distribution Systems # 58392 which will fit tongue weight capacities up to 800 lbs. This is the same bracket that comes with the # RP6637.

The # RP21501 is for TW capacities up to 600 lbs. I believe the hooks are the same size, so the chains may not be correct on your system. If this is the case, I recommend the Reese Replacement Weight Distribution Chain Kit # 3216.

expert reply by: Jason S

0

Answer 1

Because your trailer is fairly heavy, I would recommend you go with 2 of the #58392 lift brackets. The 58392 has extra gusseting welded to it for reinforcement, and would be better suited to a heavier trailer like yours, because the spring bars will…

view full answer...

Answer 2

It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…

view full answer...

Answer 3

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 4

A lot of the older Atwood water heaters have been discontinued, yes. For your replacement I recommend the Atwood RV Water Heater #AT94022 which is a 10 gallon gas/electric unit like you currently have with an automatic pilot. This uses 120V power and…

view full answer...

Answer 5

I sure can Bob and thanks for the information! Since you have a Lippert 3,500 lbs axle you'll be able to use the Easy Grease Trailer Hub and Drum Assembly for 3.5K Axles item #AKHD-545-35-EZ-K, you were looking at. These have a 5 on 4-1/2 lug nut…

view full answer...

Answer 6

I can indeed; the correct replacement for your 8-207 Dexter hub and drum is the following: - Dexter Trailer Hub and Drum Assembly for 3,500-lb Axles - 10" Diameter - 5 on 4-1/2 #84546UC3

view full answer...

Answer 7

While we are able to ship you 3 of the Master lock #ML377KA that will use the same key, we are not able to guarantee any specific key code. So will you get 3 keyed alike locks? Yes. Will they have the 0370 Key? Probably not.

view full answer...

Fit and Compatibility of Weight Distribution System Chain Lift Brackets

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching