Trailer Jack Replacement Recommendation for 2002 Bantam B19
Published 09/26/2017
Products Featured in This Question
Question:
I appreciate that what is the measurement of the outter diameter
asked by: Chuck
0
Expert Reply:
I looked up your trailer and found that it's a standard A-frame trailer so for a jack the # TJA-5000S-B which is a very popular option would fit and work well. It's a sidewind trailer jack with a 5,000 lb capacity.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Round A-Frame Trailer Jack - Sidewind - 15-5/8" Travel - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jacks
- Standard Grade
- 4001 - 5000 lbs
- Manual Jack
- 16 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: tongue jacks
- Search Results: tongue jack
- Shop: RV Exterior Lighting
- Shop: Round A-Frame Trailer Jack - Topwind - 14-3/4" Travel - 2,000 lbs
- Shop: Round A-Frame Trailer Jack - Sidewind - 15-5/8" Travel - 5,000 lbs
- Shop: A-Frame Trailer Jack - Sidewind - 1,000 lbs. by Dutton-Lainson
- Shop: Removable Wheel for Dutton-Lainson A-Frame Trailer Jack Model 6418
- Q&A: Sidewind A-Frame Trailer Jack that Can Have Handle Orientated on Front of Jack
- Q&A: Replacing A-Frame Surge Brake Actuator On 1966 Scotchman Camper
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Mounting Hole Dimensions and Spacing on etrailer.com A-Frame Trailer Jack # TJA-5000S-B
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: How to Determine the Correct Jack Height and Lift Needed for Replacement Trailer Jack
- Q&A: Will A Spare Tire With A Higher Load Rating Be Ok On A 2022 Aluma 7814ST?
- Article: Trailer Wiring Diagrams
- Q&A: Hardware Typically Used to Install A-Frame Trailer Jack
- Article: Most Popular Wheel Bearings
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Best Camper Jacks
Chuck
9/25/2017
Problem has been the outter diameter is to big. fits in the top hole but the lower hole is a bit smaller. I need inner leg to be 1-3/4 inch