Where Do Plunger and Rubber Socket Door Holders # PLR62-66 Typically Mount, High or Low
Published 09/14/2017
Question:
Hi, Are these normally mounted at the top of the doors so you dont run into them if mounted lower?
asked by: Chip
0
Expert Reply:
I've seen rubber socket/plunger kits like the part # PLR62-66 on the bottom of the doors more frequently than the top. That could very well be because it's easier to install them lower though.
If you prefer them at the top there's no reason you couldn't. It would probably stress the door less having them up top too since that would be closer to where you'd be pulling on the door from.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Plunger and Socket Trailer Door Holder - 1-3/4" Plunger - Zinc Plated Steel
- Trailer Door Holders
- Plunger and Socket
- Straight
- 1-3/4 Inch Long
- 2-1/2 Inch Hole Spacing
- Rubber
- Polar Hardware
more information >
Continue Researching
- Search Results: rv door holder
- Search Results: rv steps
- Q&A: Recommendation For Stable Single Step For RV
- Search Results: grab handle
- Search Results: rv door parts accessories and parts
- Search Results: door holder
- Search Results: entry grab handle
- Search Results: magnetic door catch
- Shop: PowerMax 30A RV Power Center and Distribution Panel - 55A DC Converter
- Shop: Mud Flaps
- Video: Feature Breakdown: Flexco Manual Pull-Out Step for RVs
- Video: Checking Out the Plunger
- Q&A: How Far Away From RV Wall Does Magnetic Door Holder for RV Doors # OBE37FR Keep Door
- Video: The Low-Down on the Plunger and Nylon Socket Door Holder
- Video: What to Know About the Lippert Manual Pull-Out Step for RVs
- Video: Feature Breakdown: Plunger and Nylon Socket Door Holder
- Video: In-Depth Review of the Easy Grease Trailer Idler Hub Assembly for 3.5K Axles
- Shop: Flexco Manual Pull-Out Step for RVs - Single - 3" Drop/Rise - 24" Wide - 300 lbs
- Shop: Plunger and Socket Trailer Door Holder - 1-3/4" Plunger - Zinc Plated Steel
- Video: Detailed Breakdown of the Carr Grab Handle
- Shop: Lippert Manual Pull-Out Step for RVs - Single - 7" Drop - 24-1/4" Wide - Steel - 300 lbs
- Shop: Plunger and Nylon Socket Door Holder - 1" Long Plunger
- Shop: Plastic Stem and Rubber Socket Door Holder - 2" Long Stem
- Shop: Flexco Manual Pull-Out Step for RVs - Single - 7" Drop/Rise - 24" Wide - 300 lbs
- Q&A: Alternative Entry Steps for 2017 R-Pod 179
- Q&A: Will Tire Size 235/85-16 Fit on Aluminum AM03 Series Gunmetal Gray Trailer Wheel # AM63NR
- Q&A: Will Replacement Closet Seal Flange Fit Thetford Aqua-Magic IV
- Q&A: What Size Valve Stem To Get For Aluminum Sendel Series S20 Machined Trailer Wheel SEN94FR?
- Q&A: Why Are New Hydraulic Brakes Getting Hot and Smoking
- Article: Trailer Lighting Requirements
Explore Expert Info
![Our Expert]()
on RV Door Parts
on RV Door Parts
