Replacement Pigtail for Optronics Rectangular LED Trailer Clearance, Side Marker Light MCL76RB

Question

Question:

Rectangular LED Trailer Clearance, Side Marker Light, 4 Diode - Red Item # MCL76RB i lost the wire plug for this light. can you give me the replacement part number please?

asked by: Dennis A

0

Expert Reply:

The Replacement Pigtail for the Rectangular LED Trailer Clearance, Side Marker Light, 4 Diode - Red
Item # MCL76RB that you referenced is part # AL42PB on our site. I confirmed this with my contact at Optronics.

expert reply by: Jon G

0

Answer 1

For your 2021 Chevrolet Silverado you will have to splice into the factory wiring to use the 3rd Brake Light Logic Module #PP20-702 to connect the left and right turn signals, along with the green wire. You can also combine this harness #PP20-702…

view full answer...

Answer 2

Yes, to run the Hot-Line LED Third Brake Trailer Light Bar w/ Reflector #328-003-6017X as a brake light only you will need the 3rd Brake Light Logic Module #PP20-702. This module will take input from both tail lights to determine when the brake light…

view full answer...

Answer 3

Hey Duke, although I don't have a Lumen rating I can give you for the Peterson Piranha LED light part #M423R-4 I can let you know that it is brighter and would be very visible in fog. If you check out the attached picture you can see how bright…

view full answer...

Answer 4

Rather than use the single Hot-Line 3rd Brake Light #328-003-6017X I recommend using 2 of the ThineLine Tail Lights #STL76RB. With this you can mount both to the roof with one on each side. This will allow them to act as turn signals and brake lights…

view full answer...

Answer 5

Hey Jim, welcome back! You are on the right track with the #APT5 kit. As long as the hanger height, shackle and equalizer length are the same, you can be sure it will work. The equalizer in the kit is 7-3/4" long center hole to center hole. The…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Replacement Pigtail for Optronics Rectangular LED Trailer Clearance, Side Marker Light MCL76RB

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching