How to Install the Replacement Electric Jack Switch with Harness # LC387874
Updated 07/11/2020 | Published 09/08/2017
Products Featured in This Question
Question:
Can you tell me which wire goes where. Trying to do it myself. Which is Pos and negative .
asked by: Duane B
Expert Reply:
I have attached a diagram that demonstrates how the typical wiring will need to be installed for the Replacement Electric Jack Switch with Harness # LC387874 that you referenced.
Black Wire - Ground Battery
Red Wire - Power Battery (20A Auto Reset Breaker # PK54520 will need to be installed in-line)
Yellow Wire (Retract) - Black Motor Wire
Blue Wire (Extend) - Red Motor Wire (6A Auto Reset Breaker # LC134181 will also need to be installed here)
Product Page this Question was Asked From
Replacement Electric Jack Waterproof Switch with Harness for Lippert High Speed Stabilizer Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Switches
- Lippert
more information >
Continue Researching
- Search Results: e99044
- Shop: Air Lift WirelessAIR Compressor System for Air Helper Springs - Remote - Bluetooth - EZ Mount
- Shop: Go Power Inter-Battery Communication Cable for 100 Amp Sun Cycle Advanced Lithium Batteries - Qty 1
- Shop: Firestone Air Command Heavy Duty Air Compressor - Remote and Smartphone App - Single Path
- Shop: Replacement Electric Jack Waterproof Switch with Harness for Lippert High Speed Stabilizer Jacks
- Search Results: air bags
- Shop: Americana Trailer Wheel Center Cap - Stainless Steel - 3.19" Pilot
- Shop: Americana Trailer Wheel Center Cap - Stainless Steel - 4.25" to 4.27" Pilot
- Video: Detailed Breakdown of the Replacement Spindle Washer
- Q&A: Replacement Rubber Bumper for Enclosed Trailer Ramp Door
- Shop: 5-Leaf Slipper Spring w/ Hook End for 7,000-lb Trailer Axles - 26-5/8" Long
- Q&A: Troubleshooting the Electric Trailer Brake Controller on 2011 Chevrolet Silverado 2500HD
- Article: Trailer Wiring Diagrams
- Q&A: Wiring Diagram for the Replacement Electric Jack Switch with Harness # LC387874
- Video: In-Depth Review of the T-Strap Hinge for Enclosed Trailers
- Q&A: How to Select Correct Weight Distribution Spring Bars to Match Trailer Tongue Weight
- Q&A: Troubleshooting Electric Trailer Jack Not Working With Fully Charged Battery
- Q&A: How to Wire the Lippert Components High-Speed Power Stabilizer Jack LC298707
- Q&A: Wiring An Electric Trailer Tongue Jack Into 7-Way Vehicle Trailer Connector
Richard V.
7/11/2020
The wiring is schematic is excellent but i have a jayco eagle ht fifth wheel the wires have rotted off cannot figure where they go, the wire broke at the connector no vinyl left my jacks also work with a remote that's the puzzling part any help is appreciated