Search: e99044   >  

The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow. This figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I…

To use the TorkLift SuperTruss Hitch Extension 48" Long item #TLE1548 with your 2023 Chevy Silverado 3500 you are going to want the TorkLift SuperHitch Magnum Trailer Hitch Receiver item #TL74FR. This hitch is custom fit and bolts to your…

The Equil-i-zer Weight Distribution with 4-Point Sway Control, like #EQ37041ET, differs from the Fastway e2 Weight Distribution with 2-Point Sway Control #FA92-00-0450, because it does utilize 2 more points of steel-on-steel friction at the head of…

Troubleshooting electric trailer brakes is much easier if you disconnect the trailer plug from the truck and test each side separately. The process is not complicated and you need only a few items. I suggest starting on the trailer. You'll just…

Curt front mount trailer hitch #31313 fits all models of the 2007 Toyota Tacoma. There should not be any interference with any of the truck components since the hitch sits out in front of the ends of the frame and in front of the bumper beam as shown…

The Bulldog Winch part #BDW15020 would be a great option for your setup. This is a 4,400 lb 12 volt winch which uses a synthetic rope instead of a steel cable. It powers in and out and has a built in brake as well. The winch also moves at 19 feet per…

Yes, the Superwinch Tiger Shark Series Off-Road Winch #SW1511200 that you referenced will fit the Curt Winch Mount part #C31010 that you also referenced. The winch has more capacity than the mount so you would have to stay under the 9k rating of the…

I can understand why this might be confusing, when it comes to the different ratings. Rolling capacity is essentially just the capacity of the winch to pull a load that is moving up an incline; technically the capacity that is listed is the maximum…

For mounting a winch to a trailer like the Superwinch #SW1455201 one solution is to weld a hitch tube to the trailer like with the part #E-9 so that you could use a winch mounting plate like the #BDW20011 and have a way to easily remove and reinstall…

I spoke with my contact at Bulldog winch and he stated that you can remove that tensioner piece you mentioned on winch #BDW15020 which should make it easier to freespool! So that is great news.

The Roadmaster Tow Dolly with Electric Brakes #RM-2050-1 will allow you to mount a hand winch. My recommendation is the Dutton-Lainson Hand Winch - Worm Gear - Hex Drive - 2,000 lbs #DL11004 which will allow you to remove the handle.

The picture for determining bolt pattern is actually a little easier than maybe it seems. You just need to measure across the wheel like it shows and then count the amount of lug holes and that's all you need. So if it's 5 inches and its a 5…