Replacement Lens Recommendation for Trailer Lens SAE AP2 04 DOT

Question

Question:

I have a 4x6 tilt trailer and need the replacement lens for tail light sae ap2 04 dot.

asked by: Shirley R

0

Expert Reply:

The SAE number is not normally a reliable way to find replacement lenses, but from previous customers who have had that same number and sent in pictures we were able to determine that the correct replacement lens is the # A39RB for the main lens and # A37RB for the side marker.

expert reply by: Jameson C

0

Answer 1

The SAE number is not a reliable way to find a replacement light for the trailer. From our experience the replacement light is Optronics tail light part #ST36RB for the passenger side or part #ST37RB for the driver's side. These lights measure…

view full answer...

Answer 2

The SAE number is not normally a reliable way to find replacement lenses, but from previous customers who have had that same number and sent in pictures we were able to determine that the correct replacement lens is the #A39RB for the main lens and…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Replacement Lens Recommendation for Trailer Lens SAE AP2 04 DOT

Continue Researching