Recommended Trailer Jack Replacement For Circle J Horse Trailer

Question

Question:

Crank handle broke on my horse trailer. It looks like the Fulton handle will work but the shaft has to be 15/32. The radius is 6.5. No manufacture or model # on this square shafted jack. Might you be able to help? Cant find one here in Reno...the trailer is a Circle J.

asked by: Mike R

0

Expert Reply:

Unfortunately the 15/32 measurement is something I can't match. The Fulton handles are thicker than that. What I recommend is exchanging your jack for a new one like the Square A-Frame Jack w/ Footplate - Drop Leg - Sidewind - 15-1/4" Travel - 5,000 lbs # TJDA-5000S. I've attached the page to all of our jack and landing gear options for you since I don't know the size or style of your particular trailer.

expert reply by: Jason S

0

Answer 1

The first thing to do is figure out how your lights get their power in the first place. Normally with your kind of setup the lights are either powered by the 12V pin on the 6-Way or 7-Way connection - this is the center pin for a 6-Way or the pin in…

view full answer...

Answer 2

We have exactly what you need. For the amber lens light you would want the Oval Clearance Light part #MC38AB and then for the red light you would want the Peterson Red Oblong Clearance Light part #423000.

view full answer...

Answer 3

SAE numbers aren't part numbers so it's hard to pick out replacement lights based on of them since that's not info that's stored as a cross reference. We've had customers with a similar number SAE-AP2-79 which turned out to be the…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Recommended Trailer Jack Replacement For Circle J Horse Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching