Will Curt Class II Ball Mount Fit into Draw-Tite Class I Trailer Hitch Receiver
Published 07/01/2017
Products Featured in This Question
Question:
Hi: Can you please confirm if curt 45015 will fit my Draw-tite Sportframe Trailer Hitch Receiver Class I - 1-1/4 ? I need something which is longer than 9inch in lenght. Thanks
asked by: Raj B
0
Expert Reply:
I just went out to our warehouse and installed the Curt Class II Ball Mount # C45015 into the Draw-Tite Trailer Hitch Receiver # 24796 and it fit perfectly. The Curt is 11-5/8 inches from the hitch pin hole to the hitch ball hole so it will work great for you.
For a 2 inch hitch ball use # 19258 and for a 1-7/8 inch ball use # 19256. Then for a pin and clip use # F-4.
expert reply by:
Charles S
0
Product Page this Question was Asked From
Curt Class II Drawbar - 5" Rise - 11-5/8" Long - 3,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- Steel Shank
- Rise - 5 Inch
- Fits 1-1/4 Inch Hitch
- 3500 lbs GTW
- CURT
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Trailer Wiring Harness Installation on a 2013 Volkswagen Golf TDI
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Least Obvious Trailer Hitch Receiver on a 2014 Honda Accord Sedan
- Q&A: What is the Towing Capacity of a 2013 Honda Accord Sedan V6
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Will Draw Bar 36065 fit a 2012 Nisssan Sentra
- Q&A: Could 2001 Honda Accord Tow Small Trailer with Motorcycles
- Q&A: How Much Can 2004 Mercury Grand Marquis Tow
- Article: How to Choose the Right Trailer Hitch Class
- Article: 5 Tips to Confidently Choose Your Weight Distribution Hitch
- Article: Trailer Maintenance Schedule
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Which Hitches are Made in the USA