Will etrailer Round, Snap-Ring Swivel Jack # TJBB-2001- B Bolt Around or Through the Trailer Frame

Question

Question:

I have an Outback 6 X 10 aluminum utility trailer built on a 1.5 X 4 in C channel frame. I want to replace the coupler mounted jack with a bolt-on, swing away model. Will the etrailer TJBB-2001-B be an easy install and specifically, will it bolt thru the frame or around it? Thank you.

asked by: Brad H

0

Expert Reply:

You might be able to bolt the etrailer Round, Snap-Ring Swivel Jack, item # TJBB-2001-B, through the frame but we do not recommend drilling the tongue of the trailer. This jack is designed to bolt around the frame.

expert reply by: Robert G

0

Answer 1

Most ball mounts can be used in either the rise or drop position. Typically if only one orientation is recommended it will specifically say, "rise only", or "drop only." To pick out the correct rise/drop ball mount you will need…

view full answer...

Answer 2

I do have an option for you but I don't have any way to reduce the ground clearance of your existing a-frame jack . That said, what you can do to fix this issue is replace your existing jack with the Ultimate Trailer Jack part #322-RDJ-2K. The…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

I apologize for any confusion on what the proper torque specs are for 1/2 inch lug nuts on trailer wheels. I attached a picture of a chart to the right that details what the proper torque specs are for a trailer wheels lugs based on lug size, wheel…

view full answer...

Will etrailer Round, Snap-Ring Swivel Jack # TJBB-2001- B Bolt Around or Through the Trailer Frame

Product Page this Question was Asked From

Continue Researching