Does Curt Adapter C57003 Fit 2011 BMW X5

Question

Question:

Will this adapter work on a 2011 BMW X5?

asked by: Pat

0

Expert Reply:

Yes, the adapter part # C57003 will fix any bulb out error codes on the dash of your vehicle caused by trying to tow a trailer with LED lights.

expert reply by: Jameson C

0

Answer 1

You would need to plug in 7-Way Trailer Adapter #C57003 directly into the 7-Way connector on your 2011 BMW X5. That way it will take care of any bulb out and brake controller pairing issues when using the Prodigy RF #TK94FR.

view full answer...

Answer 2

It sounds like you are looking for an adapter like the Curt 7-Way Trailer Adapter #C57003. This 7-Way connector will plug directly into your existing 7-Way socket so that it is able to recognize LED trailer lights. Factory tow package on many German…

view full answer...

Answer 3

There is an issue with German vehicles (Audi, Mercedes, Porsche, BMW, Volkswagen, and so on) and trailers with LED lights. The LED trailer lights do not offer enough draw on the system for the lights to work. On a lot of these vehicles you will also…

view full answer...

Answer 4

The now-discontinued Prodigy RF you asked about can have serious issues pairing with European vehicles and while this used to be the only option for a wireless brake controller, that isn't the case anymore and I recommend an alternative that…

view full answer...

Answer 5

The issue with your Volkswagen with the trailer wiring is the draw on the trailer is not enough. What will solve your dash issue as well as your trailer lighting issue is the 7-Way Trailer Adapter for VW, Audi, and Porsche Towing Trailers with LED…

view full answer...

Answer 6

There is not a custom fit at this time for your 2018 VW Tiguan with 4Motion. The custom fit harnesses from our manufacturers exclude the 4Motion. Because there is not a custom fit, your best option is to use the ZCI Circuit Protected Vehicle Wiring…

view full answer...

Answer 7

The Replacement Furrion Monitor Power Cable #C-FOS07TAPK-006 powers the monitor. I believe you are looking for the 7-Way Vehicle Power Adapter #FR87PR that eliminates the PWM issue that causes the Furrion Vision S #FOS05TASF cameras not to get the…

view full answer...

Answer 8

Any brake controller should be on a separate pin from the turn/brake light circuits so using the 7-Way Trailer Adapter #C57003 should not activate the brakes on your trailer (see attached picture). With that being said, there could be something going…

view full answer...

Answer 9

What you'd need is a 7-way adapter that has diodes built into the circuits which will absorb the small voltage spikes you are seeing with your Land Rover. For that you'd just need the part #C57003 and you'd be set.

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Does Curt Adapter C57003 Fit 2011 BMW X5

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching