2008 Mercedes-Benz ML350 Issue With LED Trailer Lights
Updated 02/09/2017 | Published 02/08/2017
Products Featured in This Question
Question:
2008 ML350. The vehicle was delivered new with trailer hitch from MB. It wont drive LED lights on the trailer - i get that hyper flashing effect on the lights. MB sold me $100 cable to fix this.....no different. I read on this site a number of similar problems and it seems there is an adapter to solve the problem. However my vehicle has a 7 pin flat connector which doesnt seem to be common/available in your connectors. Any ideas or suggestions? Thanks
asked by: MGoz
Expert Reply:
Yes. High-efficiency LED type trailer lighting pulls much lower current than standard incandescent lights. This can cause odd behavior from the wiring harness but there's a simple solution to this issue. You can install a load resistor at each affected LED light. Load resistors mimic the electrical signature of incandescent lights to let the trailer wiring work as intended.
If your trailer lights use a PL-3 type connector you can use Optronics part # ALEDRST2B. If you need to hard-wire the load resistors we offer a 2-pack of the ceramic type # DI34ZR.
7 pin flat connectors on not standard and we do not have an adapter. You will need to cut the 7 way off and rewire it to a 7 way standard like # 30717. I've attached a photo to help.
Product Page this Question was Asked From
Optronics Load Resistor for LED Lights - Male PL-3 Plug and Female PL-3 Plug - Qty 1
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Aluminum
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: optronics trailer lights
- Search Results: 2 trailer ball
- Search Results: backup trailer lights
- Search Results: curt aluminum
- Article: Trailer Wiring Diagrams
- Shop: Trailer Wiring
- Shop: Towing Mirrors
- Q&A: Are There Custom Fit Towing Mirrors for a 2021 Chevy Silverado 1500?
- Video: Optronics LED Trailer Lights | Straight from the Manufacturer
- Video: Checking Out the Optronics Load Resistor for LED Lights
- Shop: Optronics Load Resistor for LED Lights - Male PL-3 Plug and Female PL-3 Plug - Qty 1
- Video: Let’s Check Out the Optronics Load Resistor for LED Lights
- Shop: Optronics Fleet LED Trailer Tail Lights w/ Grommets - Stop,Turn,Tail - Submersible - Oval - Qty 2
- Video: All About the GloLight LED Trailer Utility Tail Light
- Video: Comprehensive Review: Fusion LED Trailer Tail Light
- Video: Peterson Load Resistor Harness for LED Turn Signals Spec Review
- Video: Review of Optronics Trailer Lights - Tail Lights 4 Function - OPT46KB
- Shop: Optronics LED Trailer Tail Light - Stop, Turn, Tail - Submersible - 10 Diode - Oval - Red Lens
- Shop: Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Shop: Fusion LED Trailer Tail Light - Stop, Tail, Turn, Backup - Submersible - Oval - Clear Lens
- Shop: GloLight LED Backup Light for Truck or Trailer - Submersible - 22 Diodes - Clear Lens
- Shop: X LED Truck and Trailer Tail Light w/ Reverse Function - Submersible - Oval - Red and White
- Search Results: trailer wiring
- Search Results: trailer lights
- Shop: Vehicle Tow Bar Wiring
- Q&A: Troubleshooting LED Lights Not Working On Trailer
- Q&A: How to Separate Out Brake and Turn Signals for LED Lighting Underneath Trailer
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Trailer Hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
on Accessories and Parts
