Distance from Bottom of the Foot to the Bottom of the Mounting Bracket on Powered Jack # BD500200
Published 10/12/2010
Question:
The retracted deck height is listed as 9-3/4. Is this from the bottom of the mounting plate to the end of the ram housing, end of the ram, or end of the foot? I need as much clearance as possible to allow the use of a powered trailer dolly.
asked by: Richard L
0
Expert Reply:
The retracted height of the Bulldog Powered-Drive 4,000 Pound Capacity Trailer Jack, # BD500200, is 9-3/4 inches, measured from the bottom of the foot up to the bottom of the bracket that mounts to the trailer frame. I have included a link to a video review of this jack below. This jack will offer the most clearance of the 4,000 pound capacity powered jacks we carry.
expert reply by:
Michael H
0
Featured Help Information
Miscellaneous Media
Continue Researching
- Video: How to Install: K-Source Snap & Zap Custom Towing Mirrors on your 2023 Chevrolet Silverado 1500
- Shop: K-Source Snap & Zap Custom Towing Mirrors - Snap On - Driver and Passenger Side
- Video: Breaking Down the K-Source Snap & Zap Custom Towing Mirrors-KS69NQ
- Search Results: k source towing mirrors
- Video: DIY 2023 GMC Yukon XL Installation for the K-Source Universal Towing Mirrors
- Q&A: Recommended Battery for Bulldog Electric Trailer Jack
- Search Results: lithium battery charger
- Q&A: Powered Bulldog Jack Recommendation for a 2011 Dodge Ram 1500 to Help Install Spring Bars of WD
- Q&A: Will a Bulldog Powered-Drive Trailer Jack A-Frame Fit a 2011 V-Cross by Forrest River Travel Trailer
- Q&A: Travel Length and Extended Length of Bulldog 4,000 lb Powered Drive Trailer Jack
- Q&A: Replacement Electric Tongue Jack that Will Allow Full Opening of Tailgate on Tow Vehicle
- Q&A: Are Fuses Needed on the Wiring for the Bulldog Powered Drive Trailer Jack BD500200
- Q&A: Can the Bulldog Powered-Drive Trailer Jack # BD500185 be Powered by 7-Way 12 V Circuit
- Search Results: electric jack trailer jack
- Search Results: bulldog trailer jack