Will Demco A-Frame Trailer Coupler DM16680-52 Fit 2015 Featherlite 3116 Trailer  

The play you are feeling/hearing is most likely between the hitch ball and the latch of the coupler. If you look under the coupler you can see an adjustment bolt that uses an Allen wrench that will allow you to tighten the latch and get rid of the…

Yes, you can use the Trailer Coupler Lock part #e98888 to prevent the hitch ball from coming uncoupled from the Demco 50-Degree A-Frame Trailer Coupler part #DM16680-52. The lock will install in the pin hole directly below the latch which you can…

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

Hello Ryan. The #CA-5196-B Ram Sleeve Lock A-Frame Trailer Coupler and the Bulldog #BD028288 are fairly similar. They are both 50 degree a-frame couplers designed for a 2" ball and both are about 16" long overall. The main difference is the…

I walked out to our warehouse and pulled the Redline A-Frame Trailer Coupler #CA5100B. At the widest point inside the coupler measured approximately 9-1/4 inches, the narrowest approximately 2 inches and 8 inches between those points. Check out the…

To install the Demco A-Frame Trailer Coupler #DM16680-52 that you referenced, you will want to use 3/8 inch, grade 5 bolts , approximately 1-1/2 inches long (depending on how you are installing the coupler). You will want to use 5 of these bolts per…

It sounds like you're looking for a replacement a-frame coupler like #CA-5280-RB but in a silver-painted or zinc-plated finish. Please click on the link provided to see all bolt-on standard a-frame couplers for 2-5/16-inch balls. For the…

Yes, you can replace your weld-on coupler with a bolt-on. You'll just need to drill the holes. Then, if you wanted to go back to a weld-on later that would be fine too. Just to confirm you can check with the trailer's manufacturer that…

The big difference between the two couplers you mentioned is that the Demco #DM13205-95 does not come with chain anchors and the part #DM16680-52 does.

The Demco 50-Degree A-Frame Trailer Coupler w/ Jack Hole item #DM13205-95 that you referenced will fit a standard a-frame trailer. This is a bolt on coupler so you won't have to borrow a welder. To install you will want to use 3/8 inch, grade 5…

The Demco coupler part #DM16680-52 that you referenced can be either bolted on or welded on. You would not need to do both to securely install it.

I would be happy to help you. I recommend the Demco 50-Degree A-Frame Trailer Coupler w/ Jack Hole and Anchors, eZ-Latch - 2-5/16" Ball - 21K item #DM16680-52. The Demco eZ-Latch mechanism will give you a simple, secure hookup, and disconnect.…