Why Would Trailer Hitch Install Bolts Not Thread Into Vehicle Frame Weld Nuts
Updated 04/07/2016 | Published 04/05/2016 >
Question:
I purchased a Curt trailer hitch for my 1997 Jeep Cherokee about two weeks ago and the bolts that came with it do not thread into the nuts in my frame on the passenger side. I tried both standard,and metric bolts that came with it and dont work.
asked by: Matt H
Expert Reply:
This is a fairly common problem on vehicles that have seen a few seasons. What ends up happening is that the weld nuts on the vehicle frame end up developing corrosion or collecting dirt and this prevents the bolts from threading in. What you will need to do is clean the threads of the weld nuts and they hardware will thread right in.
I attached a help article and video that details how to do this for you to check out.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Carriage Bolts That Come With Curt Trailer Hitch Receiver 13084 and How To Clean Weldnuts
- Q&A: Replacement Hardware For Curt Trailer Hitch on 2000 Jeep Cherokee
- Q&A: Recommended Off-Road Brake Controller for a 2024 Ford F-150
- Q&A: Trailer Wiring Recommendation for 1996 Jeep Cherokee that Doesn't Not Require Splicing
- Q&A: Replacement Hardware For Curt Trailer Hitch 13084
- Q&A: Can Brake Actuator Be Used For Single AND Tandem Axle Brakes On Trailer?
- Q&A: How to Clean the Weldnuts of a 1998 Jeep Cherokee to Install a Curt Hitch
- Article: Roof Rack Information
- Article: Must-Have Flat Towing Components
- Article: How to Choose the Right Trailer Hitch Class
- Article: Troubleshooting 4 and 5-Way Wiring Installations



