Could the Dexter Heavy Duty Suspension Kit K71-360-00 be Used with 34 inch Axle Spacings

Question

Question:

Will part # K71-360-00 work with 34inch axel spacing?

asked by: Junior V

0

Expert Reply:

The # K71-360-00 is designed for use as a replacement equalizer kit for a triple axle setup with 33 inch axle spacings. That being said, if your leaf springs happen to be 1 inch longer and have a 34 inch spacing this kit would work too.

The most important factor is that your leaf springs are 1-3/4 inches in width.

expert reply by: Jameson C

0

Answer 1

The Dexter Heavy Duty Suspension Kit part #K71-360-00 has bronze bushings and wet bolts whereas the Triple-Axle Trailer Hanger Kit part #APTT3 has nylon bushings and standard bolts. The bronze bushing resist wear more than nylon and the wet bolts…

view full answer...

Answer 2

It is possible that The Dexter Heavy Duty Suspension Kit #K71-360-00 will fit your 2005 Weekend Warrior Superlite, but you will have to measure the length of your existing equalizers and shackle straps to 100% determine if it would work. The…

view full answer...

Answer 3

It is very possible that the Dexter Heavy Duty Suspension Kit #K71-360-00 you were looking at will fit your 2008 Heartland RV Cyclone 5th Wheel Triple Axle Toy Hauler, but to confirm this you will want to measure the length of your existing…

view full answer...

Answer 4

You are right on. Since you have 33" axle spacing and 6000lb axles on your triple axle toy hauler I recommend the Dexter Heavy Duty Suspension Kit #K71-360-00 as it was designed to work with trip axle trailers with 33" axle spacing and…

view full answer...

Answer 5

On equalizer 013-105-04 in kit #K71-360-00 the eye center to eye center measurement is approximately 7-1/2 inches.

view full answer...

Answer 6

In order to determine the correct leaf spring hanger locations on a trailer you first need to position the axles correctly. I have attached a help article on this part of the process for you. Then, once the axles are correctly positioned you can then…

view full answer...

Answer 7

We have one double-eye leaf spring that has a 7,000 lb axle rating. For that you would want the part #e64SR. The hanger kit you would need then to go with that is the Dexter Heavy Duty kit part #K71-360-00. The axle spacing will be 33 inches which is…

view full answer...

Answer 8

It sounds like the Replacement Shackle Link with Bolts #018-026-05 that you referenced is what you are needing. It comes with the shackle and wet bolts that have a grease zerk fitting installed on them. This kit is compatible with the following heavy…

view full answer...

Answer 9

The Dexter Heavy Duty Suspension Kit #K71-360-00 has equalizers are 7 inches from bolt hole center to center and 5-3/4 inches bolt center to center. This kit when used with double eye springs like #e64SR will give you the 33 inch on center axle…

view full answer...

Answer 10

The Hanger #28-5 spacing for the Dexter Heavy-Duty Suspension Kit #K71-360-00 on your triple axle trailer is going to depend on the length of the leaf springs you are using. With the 6-Leaf Double-Eye Spring #e76SR having a length of 24-7/8"…

view full answer...

Answer 11

I recommend using the Dexter Heavy-Duty Suspension Kit for Tandem-Axle Trailers - 1-3/4" Wide Double Eye Springs #K71-359-00. This kit has heavy duty shackles, wet bolts, and also equalizers with built-in grease zerks. This will give you…

view full answer...

Answer 12

There are different hangers that you could use with the Dexter heavy duty suspension kit #K71-360-00. To achieve 4-1/2 to 5 inches clearance between the trailer frame and axles you could use 6 of hanger #28-5. To achieve 3-1/2 to 3-1/4 inches…

view full answer...

Could the Dexter Heavy Duty Suspension Kit K71-360-00 be Used with 34 inch Axle Spacings

Product Page this Question was Asked From

Continue Researching