Question:
Folks, Might you be able to get dimensioned part drawings for the Curt 13234 and Draw-Tight 75234 hitches? Id like to know how far back the end of the receiver is for both hitches. I prefer the hidden cross tube but not if the hitch extends out too far. I did an aftermarket hitch vs. a factory installed one for a Toyota Highlander and regretted it since the hitch kept catching my shin as I was using the cargo hatch. Also, are there any hidden cross tube hitches that dont have the 2 skeginch plates below the receiver tube? It seems like they reduce what little ground clearance there is anyway. Thanks.
asked by: Paul B
Expert Reply:
We don't have the drawings you are looking for, but if you check out the pictures I attached you will see that both the Draw Tite part # 75234 and the Curt # C13234 do not extend out past the rear bumper at all.
Since you prefer the hidden cross tube the Draw Tite will be the hitch to go with. There isn't a version without the lower safety chain loops though.
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"