Can LED Trailer Lights Ground to Frame of Trailer
Published 09/10/2015 >
Question:
I am converting my trailer lights from incandescent to LED. The trailer now uses the frame as the ground for each light. Do I use the frame for each LED light or do I run a ground wire back to the trailer tongue ground point from each LED light? Ive heard both opinions... Thanks
asked by: MIke C
Expert Reply:
LED lights can ground the same way as incandescents. If your previous setup had the grounds ran to the trailer frame and everything worked then the same setup would work with the LEDs.
I attached a help article on trailer wiring for you to check out as well.
Product Page this Question was Asked From
Uni-Lite LED Clearance and Side Marker Light w Grommet - Submersible - 2 Diodes - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 3/4 Inch Diameter
- Amber
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: rv vent garnish
- Shop: Trailer Hub and Drum Assembly - 3,500-lb Axles - 10" Diameter - 5 on 4-1/2 - Pre-Greased
- Q&A: Replacement Bearing Kit for UFP 3,500 lb Trailer Axle
- Shop: Easy Grease Trailer Hub and Drum Assembly for 3.5K Axles - 10" - 5 on 4-1/2 - Pre-Greased
- Shop: Titan 5 on 4-1/2 Hub and Drum - Hydraulic Brakes - 10"
- Shop: Timken Bearing Kit, L44643 Inner/Outer Bearings, L44610 Inner/Outer Races, 204507 Seal
- Q&A: Adapter to Allow LED Trailer Wiring to Connect to 2019 Ford F-150
- Q&A: Which Folding Handrail Is the Strongest? A Stainless Steel or Aluminum One?
- Search Results: steps
- Search Results: safety step
- Search Results: retractable step
- Search Results: trailer tug
- Search Results: stairs
- Shop: Ceiling Garnish for Ventline Roof Vent - 2-1/8" Leg - 14-1/4" x 14-1/4" - Polar White
- Shop: Ventline Ventadome Trailer Roof Vent - Manual - 14-1/4" x 14-1/4" - White - Birch Trim
- Video: A Closer Look at the MORryde Safe-T-Rail Telescoping RV Hand Rail on a 2025 Brinkley Model Z Fifth W
- Video: Detailed Breakdown of the Lippert Electric Tread Lite Step for RVs
- Video: Lippert SolidStep RV and Camper Steps Manufacturer Review
- Video: Ultimate Overview of the Lend-a-Hand Folding Grab Handle for RVs
- Shop: Trailer Wiring
- Q&A: Why Would 7-Way Adapter 20142 Only Work for a Few Hours
- Q&A: Difference Between Tow Ready # 20142 and Curt # C57003 Adapters with Lamp-Out Sensors
- Shop: Flexco Manual Pull-Out Step for RVs - Single - 3" Drop/Rise - 24" Wide - 300 lbs
- Search Results: curt 57003
- Video: A Closer Look at the 7-Way Trailer Adapter for Towing Trailers with LED Lights
- Video: All About the Load Resistor Kit for LED Turn Signals
- Video: Optronics Sealed Thin Line Two-Bulb Trailer Clearance Light Installation
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?


