Replacement Side Marker Lights for a 2000 Tracker Trailstar Boat Trailer

Question

Question:

I have a 2000 Tracker Trailstar trailer for a Tracker Pro Crappie 175 boat. Can you recommend LED side marker and fender clearance lights for this kit? Thank you,

asked by: John

0

Expert Reply:

I pulled up some pictures online of what appears to be your boat trailer and it looks like there is a cutout on the fenders that will allow a light to install with a grommet.

Without knowing what size the lights are the best option I can give you would be to check out the link I attached that will take you to a page that has all of the oval shaped, recessed mount trailer taillights we offer. You will want to select your light size from the filters and the correct lights will be listed.

expert reply by: Jameson C

0

Answer 1

In order to replace the taillight on a Trail Star Trailer you'd simply find one with the same style (shape/function) and then choose the correct replacement based on size. There are several types of Trail Star Trailers so it would be difficult to…

view full answer...

Answer 2

For a vent cover to use with the Ventline E-Z Lift Ventadome #V3092-601-00 so that you can attach to the four mounting brackets of the vent you would want to use one specifically designed for it. For that you would want the MaxxAir Cover part…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Replacement Side Marker Lights for a 2000 Tracker Trailstar Boat Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching