Recommended Firestone Air Suspension And Spacers For 2010 Chevrolet Silverado With 6 Inch Lift Kit

Question

Question:

Hello. I have a 2010 Silverado with. 6inch lift can I still use this air bag system? Or is there a spacer that I can buy to make it work for my truck?

asked by: Julio

0

Expert Reply:

The Firestone Vehicle Suspension System, part # F2430 is designed to work well with your 2010 Chevrolet Silverado. We also have a lift kit that will work with this system.

The Lift Spacers for Firestone Ride-Rite Air Helper Springs, part # F2375 will work with a system that is installed on the axle, like the # F2430. This is designed to fit vehicles with a 6 inch lift and from 11.5 to 12.5 inches between the upper and lower brackets.

I have attached a link to an installation video for the # F2430 system you can check out.

For ease of controlling the amount of air you have in the system I recommend an onboard compressor like part # F2178. This is a dual-gauge system that allows you to control each side of the air system from the comfort of your truck cab.

expert reply by: Jeffrey L

0

Answer 1

As long as you don't have a 5th wheel or gooseneck hitch installed, then we have a Firestone Ride-Rite kit that will work for you. I recommend installing the Ride-Rite Kit, #F2445, because you can use the Ride-Rite Lift Spacers for a 6 inch Lift,…

view full answer...

Answer 2

You would just need the 6 inch spacers, #F2374. Using 2 sets of the 3 inch spacers is not a good idea because the more components you add to the system the more points of weakness there are. Not that the spacers or system are weak but if you can…

view full answer...

Answer 3

To determine what size lift spacer to use on your vehicle with Firestone Ride-Rite Air Springs, measure the distance between the upper and lower brackets of your air helper spring kit, and whether the kit mounts on the leaf spring or the axle. The…

view full answer...

Answer 4

The Firestone Ride-Rite Air Helper Springs you selected, #F2445 are a fit for your 2015 Toyota Tundra. In order to accommodate your 6" lift, you will need the 6" Lift Spacers, #F2375. These spacers are installed between the top of the…

view full answer...

Answer 5

For vehicles with 6 inch suspension lifts you would need to use the part #F2375 which is a 6 inch spacer kit. This will work well with the Air Lift kit part #AL57289 that you referenced.

view full answer...

Answer 6

That's a good looking truck! To determine which lift spacers you will need for Firestone air bags #F2299 or #F2701 for your 2007 Dodge Ram 2500 there is a measurement needed. A 6 inch lift may not increase the distance between the frame and axle…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 12

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Recommended Firestone Air Suspension And Spacers For 2010 Chevrolet Silverado With 6 Inch Lift Kit

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching