Trailer Hitch that Does Not Require Drilling for a 2000 Toyota Camry

Updated 04/14/2015 | Published 04/11/2015

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"

(96)

$226.52

1-7/8" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 2,000 lbs

(2619)

$17.03

2" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 3,500 lbs

(2619)

$17.30

Draw-Tite Drawbar for 1-1/4" Hitch - 2-1/8" Rise, 2-3/4" Drop - 6-5/8" Long - 2K

(2328)

$33.46

Curt Drawbar for 1-1/4" Hitches - 3-1/8" Rise - 9-1/4" Long - 3,500 lbs

(2273)

$39.92

Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(23)

$39.74

Question:

How many extra holes would I need to drill to use this product? Is there one where no drilling is required? Thanks.

asked by: Esmond

Expert Reply:

There are 2 holes that have to be drilled in the bottom of the frame to install Curt trailer hitch # C12339 on your 2000 Toyota Camry. I have included a link to the installation instructions for you so you can see the installation steps. I have also linked a video showing how the hitch installs.

All of the Class II trailer hitches for your Camry require drilling, so I recommend sticking with the above hitch recommendation.

If you tow with the Curt hitch # C12339 you'll also need a ball mount # C45520. For a 1-7/8 inch ball use # 19256 and for a 2 inch ball use # 19258.

And for trailer wiring use # C55358. I have linked the instructions for the wiring as well.