Trailer Light Fuse in 2004 Chevy Silverado Blows When Any Trailer is Connected to 7-way
Published 02/26/2015
Products Featured in This Question
Question:
When I connect any trailer to my 2004 Chevy Silverado Truck 7 pin connector, it will blow the 10a fuse located at the drivers side dash. This fuse goes to the left rear trailer brake/trun. I replaced the flasher module. I thought maybe it had a ground on the yellow wire from the 7 pin connector but I cannot find out where this wire terminates at.
asked by: Tommy H
Expert Reply:
Since you have the issue with your truck's trailer left turn fuse blowing no matter what trailer is connected, the issue is likely to be in the truck's 7-way socket or the wiring leading to it. Corrosion can build up in the truck's 7-way socket - either on the pin contacts themselves or even inside the back of the connector - and this can cause two circuits, such as the trailer left turn/brake circuit and the 12V auxiliary trailer power circuit, to become bridged together.
The round U.S. Car vehicle connector that plugs in at the back of your 7-way (such as the Pollak # PK11893 7-way you referenced) can also develop corrosion that can cause circuit bridging upstream of the socket itself.
Either of these corrosion issues could cause a short and blow the fuse. You might want to refer to the linked article on wiring and dielectric grease, which can help prevent wiring corrosion issues. We offer part # LT37534 for protecting and preserving solid electrical connections. Look for any wires that have bare metal exposed and repair as needed.
I suggest you disconnect the round connector from the back of the 7-way and inspect it and the 7-way. Clean with an aerosol contact cleaner and a small nylon brush - avoid using metal brushes as these could leave a stray metal strand that itself could cause a similar issue. Most auto and electrical stores will carry an aerosol contact cleaner. Sometimes even just trapped moisture or dirt within the connector can cause a short. Once cleaned, apply dielectric grease.
If you have a circuit tester like # PTW2993 you can test the truck socket functions without the trailer connected. If you refer to the linked photo of a 7-way, you'll see the common pin/function configuration. Usually, the ground wire is made of white, and the yellow wire carries the left turn/stop signal. You can apply the grounded tester to each circuit on the 7-way, one at a time while a helper activates each vehicle function in the truck, to see if those functions operate properly without a trailer connected.
I also suggest making sure the 10-amp fuse is the correct value for the left turn/stop circuit.
Product Page this Question was Asked From
Pollak Replacement 7-Pole, RV-Style Trailer Connector Socket - Vehicle End
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- 7 Blade
- Plug Only
- Pollak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: trimax locks hitch pins and clips
- Search Results: rm751490
- Search Results: blue ox tow bar cover
- Search Results: blue ox hitch adapters
- Q&A: Installation of Curt RVi Series Towed Battery Charger+ in 2025 Ford Ranger Raptor
- Q&A: Wiring Harness For Flat Towing A 2025 Jeep Wrangler JL
- Shop: Curt RVi Series Towed Battery Charger+ for Flat Towing
- Shop: Vehicle Tow Bar Wiring
- Shop: Base Plate for Tow Bar
- Shop: Vehicle Tow Bar Brake System
- Shop: Blue Ox Universal Tow Bar Cover - Fits All Motorhome-Mounted Blue Ox Tow Bars
- Search Results: electrical grease
- Q&A: Best Flat Tow Setup for 2026 Jeep Wrangler
- Video: Curt RVi Series Shadow 2 Flat Tow Brake System Feature Review
- Video: Roadmaster Smart Diode Kit Installation - 2025 Jeep Wrangler Unlimited
- Video: How to Install the etrailer Invisible Base Plate Kit - 2025 Jeep Wrangler
- Q&A: Keyed Alike Trailer Hitch Lock for 2-1/2 Inch Trailer Hitch
- Video: Installation Guide for the Roadmaster Stop Light Switch Kit on a 2021 Jeep Wrangler Unlimited
- Video: Detailed Breakdown of the Torque Wrench
- Video: An In-Depth Look at the Roadmaster Stop Light Switch Kit
- Video: Review of Blue Ox Tow Bar Accessory Kit - BLU64TR
- Shop: Loctite RTV 598 High-Performance Silicone Gasket Maker - Black - 2.7-Fl Oz Tube
- Shop: etrailer Invisible Base Plate Kit - Removable Arms
- Shop: Curt RVi Series Shadow 2 Flat Tow Brake System - Wireless Monitor - Proportional - Fixed
- Shop: Blue Ox Towed Vehicle Battery Charge Line Wiring Harness
- Shop: Trailer Hitch
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Q&A: Does Standard Diode Wiring Kit Fit 2023 Jeep Wrangler For Flat Towing
- Search Results: fits passenger side towing mirrors
- Shop: Towing Mirrors
on Custom Fit Vehicle Wiring
