What is the Inside Width of the Roller in CE Smith 4-Inch Spool Roller Assembly

Question

Question:

I wondering how wide the inside of the roller is. I want to use a bracket/roller like this to run my winch strap on the front of my boat trlr. The strap on my electric winch is 2 inches wide. Thanks

asked by: Dave K

0

Expert Reply:

I went out to the warehouse and pulled spool roller assembly # CE10400G to measure the inside width for you. The inside width is 1-3/4 inches so it will not work for you. Instead you will need a 5 inch assembly such as # CE32150G or # CE10451G.

Please note that the rollers are not tested for use with a winch so I can't say whether or not it would work for that application.

expert reply by: Michael H

0

Answer 1

I went out and pulled a CE Smith Roller Assembly part #CE10401G and found that it has a distance of 3-5/8 inches from where it mounts to the center of the roller.

view full answer...

Answer 2

As shown in the brief video and photo that I have prepared for you, the height of the rubber spool roller's center portion above the bottom of the frame on the CE Smith Spool Roller Assembly #CE10400G is 8-inches to the center of the roller and…

view full answer...

Answer 3

While the photo did not come through, I can tell you that the dimension from the outside of the roller (with the caps) to the outside of the plate is 4-7/8 inches for the CE Smith Spool Roller Assembly for Boat Trailers - Galvanized Steel and Black…

view full answer...

Answer 4

I have a solution for you, but since the center to center space of the mounting slots on the CE Smith Deep V Keel Roller, 5 Inches #CE10401G measures 3 inches, the roller will not mount to your 3 inch wide trailer frame. There will not be enough room…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

What is the Inside Width of the Roller in CE Smith 4-Inch Spool Roller Assembly

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching