Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
This 3/4" round Piranha LED clearance and side marker light uses a single red diode that runs brighter and cleaner than old-style bulbs while drawing just 0.07 amps at 12V. It’s rated for up to 100,000 hours of operation, so you won’t be swapping out bulbs or dealing with burnt filaments. The LED design is more efficient too, giving you better visibility without putting strain on your electrical system.
When it comes to being seen, this light does the job right. The PC rating means it produces a full 180-degree beam pattern—90 degrees to either side of centerline—so it can function as both a clearance light and a side marker light when properly mounted. That wide spread makes your trailer easy to spot from the front, rear, or side, keeping you safer on the road and in low-light conditions.
Installing this light is straightforward and gives a smooth, professional finish. It’s designed for recessed mounting with the included grommet that fits a 3/4" hole. The compact body sits neatly against the surface, protecting it from bumps and snags. Whether you’re upgrading or replacing an old unit, the simple setup saves time without needing any special tools.
Built to handle regular use, this light has a durable plastic base and acrylic red lens that resist cracking and wear. The hardwired 2-wire pigtail eliminates plug corrosion problems—just connect the power lead and ground wire and you’re ready to go. With its solid build and dependable LED design, it’s made to keep shining mile after mile within its 8V–16V operating range.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hello everybody, this is Jeff at etrailer.com. Today, we're gonna take a look at the Piranha Round LED Trailer Clearance or Side Marker Light with the rubber grommet and the red lens. Now, this is a small 3/4 inch diameter round LED trailer light that'll function as both either a clearance or a side marker light when it's properly mounted. It is a Piranha series, which combines the modern design with nice vibrant lighting for a unique look. Now, I am gonna hook this up to some 12 volt power just to show you how bright the light is. So we'll go ahead and hook up our ground, and then we'll go ahead and hook up our power, and I'll go ahead and turn on our 12 volt, and there you can see the light light up.
I'll go ahead and turn off the overhead lights, and you can see how bright this light is, it is a red lens, so it gives you off a red light. Just zoom out so you can see it from a distance. Zoom back in and turn back on our overhead lights, turn off our power. It is a PC rated light, so it will produce 180 degree beam pattern. It is in a durable plastic base with a nice acrylic lens, and as I mentioned, it's a red lens over a red LED.
And what's nice is the LEDs make great replacements for incandescent lights, they're rated for up to 100,000 hours of operation, and they're more efficient, 'cause they'll provide brighter light with less power output, and of course, no bulbs to replace or brittle filaments to break. This is compatible with 12 volt DC system. It is a recessed mount, you can see it does include the rubber grommet right here. You just push that grommet down just to show you. And there's your grommet right there, and again, once you install that, put your grommet into the hole, pop your light in there, and it's all ready to go.
Now, it is a recessed mount with the grommet, it does require 3/4 inch diameter hole to install it in. It is a two-wire pig tail. You can see it uses the plug-in bullet connectors for the power and the ground, wire length is about six inches. Now, this light is DOT, Department of Transportation compliant, it is a P2 rated light and it is made in the USA. Dimensions again, the diameter is 3/4 of an inch, the depth of the light is 13/16 of an inch, and the power draw at 12 volts is 0.07 amps.
But that should do it for the review on this Piranha Round LED Trailer Clearance or Side Marker Light with the rubber grommet and the red lens..
Ratings & Reviews
Eric R.
10/24/2018
LIghts still working a year later
Patrick B.
4/11/2014
I will follow up with our Warehouse team so we can better label these lights.
Eric R.
10/24/2018
still working a year later
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Jeff B.
8/26/2025
Still going strong. No issues.