To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
These Through feet help you mount 2 Inno Aero crossbars to your vehicle's naked roof to create an extended-length roof rack. Locking covers secure system to roof.
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Evangeline: Hi, it's Evangeline from etrailer.com and today we are looking at our Inno Roof Rack system consisting of Inno Aero Crossbars, Inno Through Feet and our Inno Fit Kit for our 2014 Toyota Prius. We have here the Aero crossbars and other than this nice aesthetically pleasing silver stripe here, these are well-designed crossbars. We make sure to have them with the wide part facing the front so that they really reduce the drag and the noise. They're also a bit shorter than maybe your other Aero crossbars, which I like because then they help with fitting other accessories on top of them. The Through Feet come with keys so we can be locked and this help secure your roof rack to your car just to prevent or deter theft. And these are also your little bit low profile feet here on your car.
And from the roof to the top of the bars it is four and a little over a half inches.Since our car has a naked roof, we do use the naked roof fit kit. So what this does is it just clamps onto your car and if you are worried about it protruding out too much, don't worry. If you install it correctly, since it's custom fit to contour against your car, you can even slam the door on it without worrying about it. It has a weight rating of 165 pounds. But when you are, especially when you're putting accessories on it or mounting things onto your roof rack, make sure to account the roof capacity of your car so that you're not overloading it.
So with all that, let's see exactly how we install this roof rack.When installing our roof rack system, well I already installed the rear bar, so we can install the front bars together. The first thing I like to do is get our silver piece here and put it on our crossbars. So we have this upside down. So you bring this in through the bottom and there's this little ledge on there that it clips onto. With this attached you can then pull it in towards the inside.
There's a little button you have to push first to get it all the way through. So that silver plate is at the very end. And from here you can attach the tower. To attach the tower, there are some clips here. And make sure that the screw is centered on top of your plate.
And with it on top of there you can then push it out. And that's in place now. From here you then attach the pad. So this . If you know it's centered . You know it's on right if it sits flush against your tower. Just like that, you just push it in.Then you can attach a hook. And to attach the hook you take out the screw. So just loosen the screw all the way until it comes out. Just like that. You put the hook in there and you screw it back on lightly. So just to make sure it's just tight enough to hold onto your tower. With the towers attached, you can then measure it to make sure it's the correct distance apart. For our front crossbars they have to be 20-1/2" from the center point. So the next thing is there's a center point here. So we just need to measure it from there. And you measure to the line on the towers, right at the middle. So 20-1/2. I just need to bring this forward a little bit right there. That looks pretty good. When you have it measured and out to the correct spot, you can then tighten down both towers. Tighten them down here in the middle.I recommend getting another set of hands just to grab the other end of the bar while you put it up there. Make sure that the tall part of the bar is facing the front. Make sure to follow the measurements in the instructions for your car. So here on our Prius we have it 2" from the door. And when you have it lined up, we can then tighten down the hook. Now this is a torque wrench, so make sure to tighten it down until you hear it click. What I recommend also is to equally tighten both sides. So tighten it down a little bit here, then go on the other side just to make sure that it's spaced even. And the final touch is just to put the caps onto your bars and your towers. So these are nice because they lock. So when you have them in there, you can then lock them in space with the keys.So my final thoughts about this roof rack is, I do like the Inno style. I do like how the bars, the arrow bars, are a bit more aerodynamic or feel a lot more profile than maybe your larger Thule WingBars or your other bars from other brands. So I think it's a good looking roof rack. It has a decent weight capacity. We have some overhang here as well with these size bars. This switch adds a nice look to our whole vehicle. And that was a look at our Inno Roof Rack system with our Inno Aero Crossbars, our Through Feet and our Fit Kit on our 2014 Toyota Prius V.
Average Customer Rating: 4.8 out of 5 stars (161 Customer Reviews)
These Through feet help you mount 2 Inno Aero crossbars to your vehicle's naked roof to create an extended-length roof rack. Locking covers secure system to roof.I bought these as part of a kit with 60" Aero bars and the appropriate kit for my 14 Flex. I spent probably an hour and a half double checking my measurements and getting them torqued down properly. I spaced the bars on top of the car just a little wider than proscribed because I was planning on carrying 4x8 plywood, and it looked better to my eye. One thing to watch for: The instructions for the car-specific kit (in my case INK263) show the foot spacing measurements for a square bar, and the measuring point for these feet and Aero bars is different. That measurement point is indicated in the instructions for the feet, not the kit. Same numbers, just different reference point. Otherwise, they look good and are rock solid.
Great racks. High quality parts. Fit perfectly. Went together easily.
I did a lot of searching before selecting this rack for my Durango RT (no factory roof rails). It is easy to reinstall once the initial process is followed, I marked my doorjambs with a sharpie and it is easy to set up. Great product!
Once I realized which bar was the front one and which was the back it was a fairly easy install. Since the measurements for the foot placement were wrong in the instructions I would suggest not tightening the feet all the way to the bars until you put it on the car. It would have been nice if both sets of rubber pads were the same, with the tunnel hook, and if they had adhesive backing to avoid losing them. I added 2 sided tape.
Started assembly last summer and finally completed installation this spring. Directions took a lot of attention to detail but were adequate. Rack went on car securely and looks great. Have attached kayak rack and a roof pod and both worked flawlessly. Would definitely recommend.
We recently purchased 2 kayaks & Thule roof racks from our local outdoor store.
After waiting 2 weeks for our roof racks and J bars to come in we found that the Thule racks did not fit our 2017 Lincoln MKX and they didn't make any racks that would. The vehicle does not have roof racks and has a moon roof.
After a couple of days searching the internet we discovered etrailer.com. We found the Inno roof racks, but still was not sure they would work. We spoke to a repesenative and he assured us that the racks we chose would fit and the Thule J bars we did return would also work. As you can see by the photos 2 days later we were happy Kayakers.
There work great and were easy to install. e-trailer rocks and so does Justin.
Seem to be well made for the price. I didn't realize that they came with locks so that was a pleasant surprise. Easy installation.
Installation was a little tricky but once the "feet" were attached to the roof and the bars properly spaced, everything wrapped up very well.
There is no noticeable wind noise with these installed.
etrailer was the only vendor who had the custom fit roof rack feet I needed for my vehicle. I was trying to put a roof rack onto a Dodge Durango SRT...not a typical vehicle for this accessory! I looked everywhere for a suitable roof rack and thought I was settling by ordering the Inno kit from etrailer. I could not have been more wrong! I am so happy with the purchase!
These are made perfectly for your vehicle. They are very secure when combined with the other Inno products. No worries of the rack system coming off. Using them to transport kayaks using kayak holders.
Instructions were a bit tough at first as each box had their own instructions and you needed all 3 boxes to complete the setup, yet after over coming that, it was a breeze to put together and they are wonderful. Well worth the money.
Easy to mount and use. Very sturdy aswell. Measurements are a bit off on width adjustment.
I’ve had the system in place for over a year now and haul dual kayaks often! I love it! The only thing I wish I could change is the wind noise that’s comes with it. But I’m sure with any rook rack system you get that.
Tule and Yakima did not have a rack for my Nissan murano. So it was a blessing to find the immo rack. It seems like it can fit any car model. It's strong and secure. I feel my equipment will be safe with this rack.
thanks to Adam for help and competent approach. Adam listened impeccably and in the shortest possible time helped to deliver the goods I needed
These feet are easy to use and go well wit the Inno system. I was worried since my car did not come with any roof racks, but this is the solution to haul things on my roof. They work well and are very secure.
Working as hoped. Easy on and off, protects the car well.
I have had countless bike racks over the years and this is by far the best system I have ever had. Fits like a glove on my F150. Easy to install, looks great and the bikes do not move when on the roof.
One was extremely hard to get on compared to the others (not sure if it had some rough machining or something), but once all we’re on, all was good
Installation went pretty smoothly. The trick is to fully understand each step before moving to the next. There are a lot of small parts which at first was a little intimidating, but soon I was able to "get with it". I love the finished product and think you helped me get a good deal. Thank you for that
The trunk arrived in Poland in perfect condition. Packed in a hard cardboard box, it has not been damaged in any way. The trunk is made with great care, it is nice, solid and quite quiet. Thank you for a successful purchase.
Installed incredibly quickly on my 2014 Prius V with some of the best instructions I could have ever asked for. Used the video as well in tandem and got it on the car in about an hour and a half with my partner. It was a lovely experience, which is sometimes difficult for couples to say in situations like this!
Excellent quality, fit and finish.
Easy to install would recommend to ever yone
Do you have a question about this Roof Rack?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.