To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
These durable, pivoting feet help you mount 2 Inno square crossbars to your vehicle's naked roof. Torque-control knob prevents overtighting. Locks and keys included. Tool-free installation.
Features:
Specs:
Customer Satisfaction Score:
96% were satisfied with this product
4% of customers were not satisfied
Ratings & Reviews
Jenny N.
6/6/2023
I was curious by what you mean that the roof rack sticks too much.
Kris
6/6/2023
Thank you for the follow up. Its the locking mechanism, it is sticking too much and its not as aerodynamic as others - see attached. Its prone to catch wind and make noise. Considering the price and that my teen would use it, its a good rack :-. Thank you for the great service! If you feel my review is misleading, feel free to not post it.
Jenny N.
3/4/2022
There are a lot of factors involved when installing and using a roof rack. For the 2018 Ford Focus Sedan the roof rack capacity is 120 pounds although you would want to also check that the manual says for the vehicle. Before tightening anything down you will want to look at the instructions to find the proper spread between the bars and also the feet. Once that is down you will take the included Allen tool and tighten down the bolt. Next you will install the fit kit which will have you start with the foot pad. The foot pad will line up with the holes at the bottom of the foot. These will push into place and are numbered so that the right pad lines up with the right foot. To install the clamp you will remove the screw from the outside and loosely tighten it up to hold the clamp into place. The next step is to measure from the center of the doorjamb you will get the measurement to the center of the bar. You will find this in your instructions. Repeat on the other side. Then you will take the tightening tool and snug it up against the door. You will do this on the passenger side as well. Then you will go back and forth from drivers to passenger side giving about five or six turns each time until its completely tightened down. When it makes the clicking sound you will know its completely tied down. You do not want to over tighten it.
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Mike L.
7/25/2019
Per your photo, I can see you have the vehicle specific clips attached to holes in the roof rail. The clips are meant to install at the tops of the door jambs. Once correctly installed, everything should fit great for you.