Upgrade your RV's ducted or ductless AC with this complete system from Advent Air. New R32 refrigerant meets 2025 EPA regulations. Not backwards compatible with any AC systems from 2024 and earlier.
Features:
Specs:
Notes:
The AC unit includes an air distribution box with a built-in thermostat. The thermostat has an LED digital display that lets you control the mode, fan, and temperature settings. If you add an electric heat strip (sold separately) to remove the chill on cold mornings, then the thermostat also controls the heat setting. Additionally, there are adjustable registers on the front and back of the box. These can be tilted up, down, or side-to-side for directing the air where needed. The removable air filter prevents dust and dirt from building up on the fan blades.
If your campsite or generator isn't able to draw the power you need, then you may have difficulty starting your AC unit. The included start capacitor, however, can eliminate this problem. The capacitor stores energy that will later be used to jumpstart the AC. Once the sufficient amount of power has been supplied to the AC, the compressor will start to run, and the internal relay switch will turn the start capacitor off. At the same time, the compressor will send "back voltage" to the relay switch and capacitor in order to energize them for the next startup.
Because your RV is likely already prepped and pre-wired for an AC unit, installation is simple and easy. Most AC units, including this one, are designed to fit an opening that measures 14-1/4" x 14-1/4". Depending on your roof setup, you may need to do minimal alterations. If the opening is larger than 14-3/8" x 14-3/8", you will need to install spacers between the sides of the unit and the opening's edges. If the opening is smaller than 14-1/8" x 14-1/8", you will need to enlarge the hole to fit the unit snugly inside the opening.
On the bottom of the AC, there's a thick, collapsible gasket with 6 noise-reducing foam pads. This provides support between the RV roof and AC and seals the opening to prevent water and outside air from leaking in. Because of this, the use of fresh sealant isn't required during installation.
To install the start capacitor, bolt it to the fan motor support with the included hardware and then route the wires to the run capacitor.
Once installed, the hard plastic cover on the AC can easily be removed for maintenance and cleaning.
2-Year limited warranty covers defective units when installed correctly on approved applications. The warranty does not cover units installed incorrectly. To ensure air conditioner is installed correctly, please see the questionnaire pdf below. A filled-out questionnaire is required for warranty coverage.
If you are not comfortable using a voltmeter (or removing the charge from the start capacitor), you'll want to make a service appointment with your local RV dealer to verify the installation. Print the pdfs below (warranty- questionnaire, warranty dealer information) and take them along with the RV to your local dealer. ASA does compensate dealers for warranty work as outlined in the dealer information pdf. You may be charged by the dealer for time spent investigating the installation.
California residents: click here
Do you have a question about this RV Air Conditioner?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.