Bright Way Trailer Breakaway Kit
- 3802311
- Kit with Charger
- Single-Axle
- Tandem-Axle
- Triple-Axle
- Battery Included
- Top Load
- Bright Way
- 10 Ah
- Electric
- LED Indicator
- 48 Inch Long
LED tester lets you easily check the battery's charge. The built-in charger in this kit keeps your battery charged and ready to bring your single-, tandem-, or triple-axle trailer to a stop should it become disconnected from your vehicle.
Features:
- Makes sure your trailer safely stops if it ever separates from your vehicle
- When the pin gets pulled from the switch, a signal is shot back to your trailer brakes to activate
- Automatically charges battery with the built-in charger when connected to your vehicle
- Won't overcharge your battery
- Lets you test battery status with the push of a button
- Mounts on the inside of your trailer's frame
- Top-loading case provides easy access to battery from above
- Breakaway switch installs on your trailer's frame with self-tapping screws (sold separately)
- Protects the battery from rain and debris with durable, plastic case
- Rubber O-ring in the lid helps keep water out of the box
- Drain holes in the bottom of the box help with venting and letting condensation drain
- Wiring diagram printed on the case's lid
- Includes breakaway switch, 2-amp charger, 10-amp-hour battery, battery box, and wiring
Specs:
- Application: single-axle, tandem-axle, or triple-axle trailers with electric brakes
- Battery:
- Voltage: 12V
- Type: sealed lead acid
- Capacity: 10 amp-hours
- Charger:
- Amperage: 2 amps
- Lead wire length: 38"
- Breakaway cable length: 48"
- Breakaway switch:
- Dimensions: 4-3/8" long x 1-1/2" wide
- Lead wire length: 47"
- Battery box:
- Dimensions: 5" long x 8-7/8" wide x 5" tall
- Mounting hole spacing:
- From center to center vertically: 1-1/4"
- From center to center horizontally: 8-1/4"
- 1-Year limited warranty
Note: A breakaway system is required by law in most states for trailers that are equipped with electric brakes and have a GTW of at least 3,000 lbs.
Built-In Battery Charger and Tester
The integrated charger keeps the included battery charged and ready to go. At any time, if you would like to see what the state of the rechargeable battery is, just push the green button and LEDs will light up to indicate the battery's status. If it's green, it means the battery is fully charged. Yellow shows it's currently charging, and red indicates a low battery.
![Image of LED indicator showing the status of your battery]()
Quick Tips:
- When you store your trailer, be sure to keep the pin plugged into the breakaway switch. If the pin's removed for an extended period of time, dirt and moisture can get into the switch and cause corrosion that could keep it from activating when you need it.
- A breakaway system needs to be able to apply the trailer brakes fully for at least 15 minutes. In general, the heavier your trailer, the higher amperage battery you'll need for the breakaway.
2311 Brightway Group (BWG) Trailer Break Away System with Switch, 12V 10Ah Battery, Switch, and 2 Amp Charger
New Warning Message
WARNING: This product can expose you to DEHP, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.p65warnings.ca.gov.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.