Miro-Flex LED Tail Light - Stop, Tail, Turn - Submersible - 16 Diodes - Red - Qty 1

See what our Experts say about this Optronics Trailer Lights

• Would the Optronics Trailer Lights # STL35RB Meet IP67 Waterproof Rating
  A submersible light such as # STL35RB is sealed and waterproof. This light is not given an IP rating but if to get an IP rating of 67 something must meet NEMA code 6 then these lights would do the trick as they are sealed and waterproof.
  view full answer...
• Flush Mounted LED Lights for Flatbed Trailer
  Thank you for the photos; based on what you showed, you would want oval LED lights that are in the 6-1/2" x 2" range, though you would need exact dimensions to ensure the right fit. For example, # STL72RB is a red oval light that measures 6-7/16" x 2-5/16" x 1-3/4" deep while # STL70RB is another red oval light but with dimensions of 6-1/2" x 2-1/4" x 1-1/8" deep. The same will apply for your white oval lights, such as the 6-1/2" L x 2-1/8" W x 1" # BUL72CB. The other lights look to be...
  view full answer...
  
• Replacement LED Light Assembly for Thule Transporter Cargo Carrier
  It's true! We (and other customers - see review below) have found that the Micro-Flex LED Tail Light # STL35RB works great as a replacement for the stock assemblies on the Thule Transporter Combi Cargo Carrier. LEDs typically last significantly longer than standard incandescent bulbs so you really shouldn't have to worry about replacing them. I wouldn't be surprised if they outlasted the carrier itself. I have attached a short video review as well.
  view full answer...
  
• Replacement Tail Light for a Thule Terrapin or Thule Transporter Hitch Mounted Cargo Box
  The replacement tail light for the Thule Terrapin cargo box is # TH05252. This is an incandescent light. There isn't an official LED light made for it but you could potentially use # STL35RB. It measures 5-5/16 inches by 3-7/16 inches and is 2-5/16 inches deep overall. I have linked a video review of this light for you.
  view full answer...
• What Size Hole is Needed to Mount the Optronics Tail Light # STL35RB
  With the Tail Light, # STL35RB, inside of the appropriate grommet, # A33GB, you would need a hole that is approximately 5-7/16 x 3-3/4 inches. You will also need the appropriate wiring harness, # A45PB.
  view full answer...
• Recommendations for installing a LED Trailer Light # STL35RB on a 2002 Ranger Trail Trailer
  This Miro-Flex, Waterproof, Rectangular, LED Trailer Stop/Turn/Tail Light # STL35RB that you referenced should work well with your trailer wiring. You will need a Straight 3-Wire Pigtail # A45PB to wire it into your trailer wiring. The red wire from this harness will run to the turn signal circuit, the black is the tail signal, and the white will ground to the trailer frame on a clean metal surface to complete the circuit. You might also be interested in purchasing a Grommet for ST33...
  view full answer...
• Depth Dimension of Optronics Miro-Flex LED Trailer Stop/Turn/Tail Light STL35RB
  The actual depth of the Optronics Miro-Flex LED Trailer Stop/Turn/Tail Light # STL35RB is 2-5/16-inches, as shown in the linked diagram which includes overall dimensions too, but you will also need to allow for the right-angle plug # A47PB which will add another inch. This light is intended for installation using rubber grommet # A33GB.
  view full answer...
  
• Replacement LED and Incandescent Lights for the Thule Transporter
  Yes, the LED light part # STL35RB can be used to upgrade the lights in a Thule Transporter Hitch Mounted Cargo Carrier part # TH665C. I went out to the warehouse and test fitted the LED lights inside the original grommet that comes with the Transporter part # 05253. The pigtail that comes with the Transporter part # TH05254 fits the LED lights so there will not be an issue plugging the new lights in. If you are just looking for the original incandescent replacement light, you can replace...
  view full answer...
• Can the Miro-Flex LED Trailer Light be Mounted Vertically and Horizontally
  As long as you have adequate room to mount the Miro-Flex, Waterproof, Rectangular, LED Trailer Stop/Turn/Tail Light # STL35RB you could mount it in basically any orientation you like. You might also be interested in purchasing a Right Angle 3-Wire Pigtail # A47PB or a Straight 3-Wire Pigtail # A45PB depending on your mounting location. Or a Grommet # A33GB for mounting.
  view full answer...
• Grommet and Pigtail Needed for the Optronics Miro-Flex # STL35RB Trailer Light
  The grommet that you will want to use to install the Optronics Miro-Flex # STL35RB is the Optronics part # A33GB. For a pigtail you have 2 different options. The 3-Wire Pigtail for Optronics Trailer Lights part # A45PB has a straight connector and the Right Angle 3-Wire Pigtail for Optronics Trailer Lights part # A47PB has a right angled connector.
  view full answer...
• Running Lamp Circuit on Thule TH665C Transporter Combi Cargo Carrier Not Working
  The taillights on the Thule # TH665C Transporter Cargo Carrier should function as brake lamps. turn signals and running lamps. It sounds like you have a problem with the running lamp circuit, as the license plate lamp is on the same circuit. I'd first test the trailer connector on the vehicle while the headlights are on. A simple circuit tester like # PTW2993 works well for this. Check the pin on the connector that's fed by the brown wire. If you're not getting power on that wire with...
  view full answer...

Do you have a question about this Trailer Light?