2022 Thor Scope Motorhome RV Jack Pads

Hello Tom, Congrats on the new 2025 heartland corterra 3.0 5th wheel, what is your favorite feature? I cannot find the exact weight anywhere for the Stackers StayPut Jack Pads and Leveling Blocks #VAL93MB. I do know that they will be able to handle…

For 10" octagon shaped jack feet you would need the SnapPad EQ Octagon Jack Pads #SN76FR that you were already looking at, but before purchasing you'll need to measure just how tall the edges stick up from the ground since your jack feet…

Since the Lippert Hydrauluic Landing Gear Feet are 12 inch in diameter and round the correct Snappads would be the part #SP74FR4.

Hey Michael, for your 2008 Forest River Salem LE 26TBSS you can use the Electric Ground Control TT Automatic 5-Point Travel Trailer Leveling System #LC672136. This is a fully electric system that will work with trailer that have a GVWR up to 10,000…

Personally I prefer the SnapPad XTRA Jack Pads #SP54FR4 over the Stromberg Carlson #SC99MR as they have been around much longer and proven themselves to be a quality product. Both these will fit 4 jacks with a 9" round landing pad.

Hey Robert, The Power Watchdog Surge Protector #HU82VR can be installed on the shore power lines before the transfer switch. Since it's before the transfer switch it would only be tied to the shore power and wouldn't be an issue with the…

Hey Frank, We would need to know the diameter and shape of the footplate for your tongue jack in order to find the correct SnapPad to fit it.

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

SnapPads like the SnapPad XTRA Jack Pads for Lippert Leveling Systems w/ 9" Round Jack Feet - Qty 6 Item #SP54FR6 can be taken off and on as needed so you won't have to keep replacing them every time you need to take them off.

The Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets #RM47MR typically comes centered and you would only need to make adjustments after installation and testing to see if it continues to pull. If you adjusted it all the way out to where…

Hey Jody, your 1/0 wire that you have for a winch wiring kit would work just fine with the Redarc Alpha 50 amp part #RED78NR. Having heavier gauge than needed would just mean you'd have max amperage available for the charger at all times.

Hey Terry! You can remove the existing stabilizer, that won't be a problem. Although additional stabilizers won't hurt anything the Electric Ground Control TT #LC672136 is enough on its own. If it were me, I would move the other stabilizer to…