Is 5-1/2 inch Fit Info for SnapPad Mini Jack Pads Diameter or Circumference

Question

Question:

Do you mean 5 1/2 inch circumference or diameter?

asked by: Duke

0

Expert Reply:

Hey Duke, this is a great question but the 5-1/2 inch dimension that is referenced for the fit of the SnapPad Mini Jack Pads part # SN27FR that you referenced is the diameter and not circumference. What diameter jack feet do you have?

expert reply by: Jameson C

0

Duke

8/12/2025

I have 4 1/2 inch diameter approximately. I have mixed feelings about the snap pads for a slide in camper anyways. Could be a good reason for the smaller diameter feet; they are a little more forgiving then a 5 1/2 inch with the snap pads. Perhaps less stress on the jack mounts.

Jameson C.

8/12/2025

@Duke Gotcha, yeah I wish we had something in your size but smallest foot size we have a fit for is 5-1/2 inches like what you recommended.

Answer 1

Hi Mark; more than likely the 5-1/2" will work but it won't be the #SN27FR. With your 5-3/4" measurement you probably need the #SN39FR for square feet. These also fit 5-3/4" round Reico Titan jack feet which are common on a lot of…

view full answer...

Answer 2

No, I am sorry Kevin we do not. The smallest snap pads we have are the 5-1/2" for round jack feet item #SN27FR. I checked with our vendors and no one had a smaller jack pad for the ovalish HappiJac Truck Camper Jack item #LC736514. My only…

view full answer...

Answer 3

Hey Jason, thanks for reaching out! The SnapPad StakPad Kit #SN24VR you asked about will work because it's a universal design to go with any jack foot configuration, but from the looks of things I bet you have the 5-1/2" round feet on your…

view full answer...

Answer 4

There is not a specific accessory of a self stick rubber pad for the Stromberg Carlson Base Pad Extreme, #SC88VR. However, there is the Stromberg Carlson RV Jack Pads for RVs and Trailers - 11" Long x 10" Wide, #SC24VR, that may interest…

view full answer...

Answer 5

The Snap Pad Jack Pad for Camper Jacks w/5-1/2" Round Feet Item #SN97FR is going to be too big to snap on to your 5.278" foot. What you can do instead is use the Stromberg Carlson RV Jack Pads for RVs and Trailers - 9" Long x 6"…

view full answer...

Answer 6

The SnapPad Mini Jack Pads #SN27FR are the smallest pads that SnapPad makes for a 5-1/2" round jack. Depending on the jacks you have for your truck camper you may be able to change out the feet for the larger diameter to still use these on your…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Is 5-1/2 inch Fit Info for SnapPad Mini Jack Pads Diameter or Circumference

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching