Hey Tod, the two UWS boxes have different shapes and capacities. If you check out the attached pictures you can see the differences between the part #UWS08298 and #UWS01044 to get a better idea. The #UWS01044 has a slightly smaller capacity at 8.2…
There is a wet bolt kit made specifically for a tandem axle trailer with Road Armor equalizers, and includes the shackles, wet bolts, and hardware needed. What you need is the following part: - Lippert AP Kit - Tandem Axle Road Armor Wet Bolts and…
Hello John, thanks for reaching out. For the wet bolts you can measure the overall length or the length not including the head. Honestly when replacing this stuff, the bolts are going to be a standard length and diameter. Typically I would not even…
The Suspension Kit for Tandem-Axle Trailers - 1-3/4" Wide Double Eye Springs #AP233 is the standard suspension kit. For a heavy duty option, we have the Dexter Axle Heavy-Duty Suspension Kit for Tandem Axle Trailers - 1-3/4" Double Eye…
Hey Floyd! Where have you heard that? I haven't come across it on our site and I don't see anything out there on forums or anywhere else. We haven't tested the etrailer Hard Tonneau Cover #e75DR with a power tailgate yet but as far as I…
The towing capacity of the 2003 Chevrolet Avalanche 1500 with 5.3L V8 and 4.10 rear axle is 8100-lbs. For a 7600-lb GVWR travel trailer the resulting 500-lb safety margin is adequate/low-ish. With a trailer that weighs substantially more than the tow…
I actually just went and test-fit SnapPads on the feet of the Lippert High-Speed Power Stabilizer Jack #LC298707 yesterday and discovered that the #SN99FR (4-pack) and #SN77FR (1-pack) are a compatible fit.
The receiver tube portion of the Curt Trailer Hitch Receiver part #C13002 will extend out past the rear bumper fascia on the 2015 Cadillac SRX so the center knockout panel cannot be reused unless modified. This will be the case for all aftermarket…
The BAKBox 2 Collapsible Truck Bed Toolbox #BAK92120 is specifically designed to mount to the side rails on BAK tonneau covers which are going to be different on your REV cover. So you will need a toolbox which fits down inside the bed like the UWS…
What you would need is a front hitch for attaching your winch to your 2012 Chevy Silverado 1500. For that you would need the part #65052 which is a confirmed fit. Then for a winch mounting plate you would want the part #BDW20011 which will fit in the…
I contacted the manufacturer in regards to the life span of the band on the Internal Tire Sensor #TST-507-INT-S1. They informed me that the band is made of stainless steel and if installed properly will outlast the life span of the battery which is…
Filters
