Welcome back Michael. The 7-Way Vehicle Power Adapter #FR87PR takes the vehicle’s PWM/insufficient running-light signal and provides a steady 12V supply so Furrion cameras can operate properly. The tow vehicle lights still need to be powered on to…
Hey David, you can replace your Coleman Mach 15 with the Coleman Mach Everest part #CM35MR and use the same wiring that's behind the walls. Everything else would need to be swapped out but the wiring can be reused. We only have the Everest in the…
Hi Toby, At this time, Coleman Mach has not announced a heat pump version of the Mach Everest RV Air Conditioner #CM63MR. The current Mach Everest is marketed as a cooling-only, variable-speed air conditioner, and I have not seen any official…
Hey Kyle! That is correct. The Coleman-Mach Mach-C Everest has variable-speed cooling and an inverter-driven compressor. However, the Mach-C Everest uses a traditional wall thermostat instead of a remote control. It also works with both ducted and…
Hi Ashley! Yes, we do. If you're looking for the PopStep kit that includes the pieces between the steps, you'll want the PopStep, GapGuards, and NightLine Kit for MORryde StepAbove 3 Step, 19-1/2 Inch Treads, Part #PS63UR. This kit includes…
Hey Jason! I'm guessing you have the 12" long shank right now which is the standard. For a longer shank that fits a 2-1/2" receiver you can use the Equal-i-zer Weight Dist Shank - 2-1/2" Hitch - 16" Long - 7" Rise,…
Hi Glenn, I was able to pull a few specs from your Dexter axle number, it looks like it is a 3.5K EZ-lube axle with 5 on 4 1/2 bolt pattern and a 2 3/8" diameter axle tube. I wasn't able to determine the hub face or spring center measurement…
What is your current tire size? The only tire size I saw mentioned online for a Flagstaff 176LTD is ST145-12 (also commonly referred to as 145/80-12). We do offer that size in a radial as part #AM10130 which is a load range D with a 1220 lb per…
Hey Bob, yes the PopStep for MORryde StepAbove #PS47UR that you referenced does come with 2 steps that are slightly shorter front to back and slightly longer one for the top to match the step sizes on the MORryde StepAbove fold down steps. Are the…
Hi Mark, You shouldn't need to use the Furrion 7-Way Vehicle Power Adapter part #FR87PR because your 2018 Ram 2500 is from the fourth generation of the Ram 2500 before they did the huge overhaul that changed the circuits and resulted in the newer…
Hi Eric - yes, that’s completely normal. The Jay Feather Micro sits lower to the ground than many larger travel trailers, so a 2-step Lippert SolidStep setup is typical from the factory. Now just verify tread width before ordering so you don't…
Hey Greg! Yeah the B&Ws are super nice and we don't hear many complaints, but I understand what you're saying about the manual sliding being annoying. The auto slides like PullRite and Demco Autoslide are a nice upgrade. For your 2026 RAM…
Product arrived very quickly. Everything was there and fit properly. I'm very satisfied.
Greg
Hillsborough, NC
RV Step Covers for 19-1/2 inch wide steps
Add traction and quiet footsteps on 19-1/2 inch wide RV steps. If your stair set has a deeper top step around 10-1/2" and lower steps around 8", spring-attached covers can easily stretch to fit. Installation is quick, with a snug, clean look that helps brush off dirt before it comes inside.
Yes, options are available that fit 2nd Gen MORryde StepAbove steps. Check that the set includes a customized wider top step with straps to go into the slots. Verify your step width is 19-1/2" and confirm your step generation before ordering.
Installation is quick and straightforward, and the fit can be snug. They help with traction, make steps quieter going up and down, and can help keep out some dirt. If a cover won't stay on, check that the attachment style (springs or straps) matches your step design and that your steps are 19-1/2" wide.
Covers with spring attachments can fit both 10-1/2" and 8" deep steps. Measure each step's depth to be sure, especially the top step if it's deeper. If your top step uses slots, choose a version with straps for that step.
Yes, they're designed for 19-1/2" wide steps like MORryde StepAbove. Measure the width to confirm. For steps with 10-1/2" top depth and 8" lower depths, the spring attachments can stretch to fit. If you have a 2nd Gen setup, look for a wider top step cover with straps that pass through the slots.
Filters
