Hey Bob, thanks for reaching out, and good question. For that setup, as long as the tray is properly secured in the portion that is touching the floor, it will be just fine. It might be a bit more difficult to install since you can't secure the…
Hi Chuck! The MORryde RV Cargo Slide Tray - 72" x 26" - 1 Way Slide - 60 Percent Extension - 800 lbs #MR67FR sits 1.6 inches above the floor you mount it on. If you want or need it to be a bit higher off the floor, you can also grab the…
Hey Ethan. From the mounting point of your RV to the top of the carpeted base is going to be 2.31" on the MORryde RV Cargo Slide Tray item #MR78RV. The bottom of the tray sits 1.57" above the mounting point on your RV and the wooden base is…
You can go with a listed 29" model of the MORryde RV Cargo Sliding Tray as its actual width is 28-3/4". Please note the attached image showing dimensions of width. We have the #MR69FR that is 90" in length by 29" wide and has a 2…
Hi Glen, It will depend on what the GVWR (gross vehicle weight rating) is of your trailer to determine which B&W 5th wheel to gooseneck adapter will work best for you. Fifth wheels and gooseneck trailers go off of pin weight instead of tongue…
While there is no visual guide available to determine the sizing for the MORryde sliding cargo trays like the #MR38FR, it really depends on the height, length, and depth of your RV compartments opening. The #MR38FR that you were looking at, for…
Hey Arthur, The dimensions I'm seeing for a 3500watt Predator Generator show it being 22.8" L x 17.3" W x 20" T so if you're wanting it to sit with the 17.3" side facing out the closest fit would be the MORryde RV Cargo…
Hey Paul! The PullRite SuperGlide #PUL43RR (2714) and #PUL73RR (2914) do weigh the same. The main difference is the capacity, which is going to come from the base of the 5th wheel hitch. Since your 2027 Keystone Cougar 316RLS has a GVWR of 12,900 lbs…
The two most likely causes of a MaxxAir vent fan lid not opening or closing are either going to be a lift motor or operator failure. I recommend removing the motor and applying power directly to this to see if the shaft turns. If not, you know the…
Hello again Bob, On the MORryde RV Cargo Slide Tray - 90" x 29" - 2 Way Slide - 60 Percent Extension - 800 lbs #MR69FR the overall dimensions are 90" long x 29" wide x 6-5/8" tall, the actual tray dimensions are 88-1/4"…
Hey Laura, as long as the sizes match like you've noted that they do the Furrion #FR77AD would fit and work great in place of what you have now! With RV microwaves like this there really isn't more to it than that. How did you like the…
RV Cargo Slides: 60 Percent Extension, 29 Inch Wide
Enjoy easy access to your storage—60 percent extension brings your gear within reach without crawling in. At 29 inch wide, it fits bays and door openings that can accommodate that width, so measure your opening for clearance. Installation is straightforward, and the sturdy slide helps you organize heavier items with less strain.
Yes, options in this size list 800 lbs capacity. Verify the capacity for your chosen length and confirm your mounting surface supports it. Check that cross braces are straight before final tightening. Due to size and weight, a two-person install helps.
Expect about 6-5/8 overall height and roughly 1-3/4 from the floor to the tray surface. Measure your floor-to-opening height and subtract that tray rise. If there's a pass-through sill, use spacer blocks or a height adjustment kit to gain clearance.
Yes, it can add to tongue weight, though not necessarily the full unit weight. If your current tongue weight is already higher than your spring bar rating, upgrade the bars before adding the slide. Mounting location and added cargo will affect the total.
No, a 29 inch wide slide is too wide for a 28 inch opening. Measure the clear door opening against the overall slide width, not just tray space. If the opening is under 29 inches, choose a narrower width.
36 Inch Long
48 Inch Long
60 Inch Long
72 Inch Long
90 Inch Long
RV Cargo Slides Parts or Accessories
Filters
