The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…
Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…
Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…
Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…
Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…
The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…
Hey Matt, Furrion typically has 4 wires running to their thermostats and the Chill Cube Thermostat #LC74DX is no exception. The harness you see with the thermostat would plug into the Chill Cube's controller and has 4 wires to extra wire to to…
Hello Joe, Thank you for reaching out! The Power Mountain Tallboy Off-Road Bottle Jack - 11-5/16" to 27-1/16" Lift - 12 Tons #PM94FR does have the capacity you’d need, but since your fifth wheel’s frame sits about 25" off the ground,…
The differences between the Firestone Ride Rite #F2613 and the Red Label #F2709 for your 2023 GMC Sierra 3500 Crew Cab Long Bed is the air pressure and max weight capacity. The Ride-Rite #F2613 are rated for 5,000lbs and 100 PSI, where the Red Label…
Hey Mike, welcome back! Both the Firestone Ride-Rite #F2613 rated for 5,000 lbs, and the Firestone Ride-Rite Red Label #F2709 rated for 7,500 lbs will keep you at factory ride height when you aren't towing. All you need to do is run the air bags…
For your 2015 GMC Sierra 3500 Denali DRW 4x4, I recommend using the Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs part #F2709 over the Air Lift LoadLifter 7500 XL Air Helper Springs part #AL57538 for two reasons. The first reason is…
Very helpful/friendly Customer Service. Competitive Pricing. Shipping was Fast.
John
Mankato, MN
Rear View Safety Mobile DVR for confident monitoring
Stay connected to your cameras on the go, with WiFi access from a tablet or smart phone available on select setups. Rear View Safety mobile DVR units may use both red and yellow 12v power leads, with the yellow tied to an ignition-switched fuse to help prevent battery drain. Some systems add an IP camera as a fifth channel that doesn't physically connect to the DVR.
Yes, but the fifth channel may be for an IP Camera rather than a physical cabled port. That means it connects wirelessly (like WiFi or Bluetooth) instead of plugging in. Check whether the extra channel is IP-only and match your camera type to the DVR's supported connection.
Yes, WiFi capability is available on some Rear View Safety mobile DVRs to access from a tablet or smart phone. Confirm WiFi support in the specs before you buy. Pairing typically requires enabling the DVR's WiFi and connecting your device to it.
Connect the red wire to 12v power and splice the yellow wire into an ignition-switched fuse. Both the red and yellow need 12v to turn the unit on. Pick a fuse that only has power when the engine is running to help prevent battery drain, and use a fuse tap for a clean install.
Verify 12v at the inline fuse and make sure both the red and yellow wires have power. The yellow accessories line should be on an ignition-switched fuse. If there's still no power, recheck the ground and that the chosen fuse only energizes with the engine running.