# 1
Hitch Adapter 1-1/4" to 2" Trailer Hitch Receiver
Solidly made. Wish all of these would come with optional locking pins and clamps to minimize movement as I use mine primarily for a bike rack with very nice bikes aboard.
# 2
Hitch Adapter 1-1/4" to 2" Trailer Hitch Receiver with 5" Rise
So far, so good. Had to cut into the bumper if my 2011 Jetta in oder to make it work. Here is a picture.
The item was very well built and arrived quickly. The only complaint I have, is a problem I was expecting to have after reading another review, so I don't feel cheated, just a little disappointed: it doesn't really fit a 2013 Jetta Sportswagen with a U-haul branded hitch. It doesn't clear the bumper. The male part the goes into the receiver needs to be just about 1.75" longer (2.00" might be better) to clear the bumper. A suggestion would be to make the male appendage 2" longer and provide two holes so people can use either the shorter or longer extension, depending on how far out they need to go to clear the bumper. (I was able to make it work by chopping off a triangular part off the top part of the unit)
# 3
Curt Hitch Extender for 1-1/4" Trailer Hitch Receivers - 7" Long
Perfect fit to extend the hitch to allow my bike rack to clear the back bumper. Great quality as well.
This hitch extension was exactly what I needed. New hitch on the Toyota Avalon has the receiver box a little too far under the bumper to fit my bike carrier. The diagonal support on the carrier didn't allow hitch pins to align without modifying (cutting) bumper. This extension was a simple yet effective solution to moving the carrier away from rear of vehicle. (Photos were taken without hitch pin in place) The item was in stock and shipped rapidly. Thank you etrailer.
# 4
Roadmaster Dual Hitch Receiver Adapter with 2" or 6" Drop/Rise
Worked out great for my family bike adventure. Traveled with that setup over 1000 miles and it was easy drive. I had cargo carrier on the bottom and bike rack on top, and with that setup and 4 people on board still plenty of ground clearance 11". Dual hitch is a solid piece of steel that can carry a lot of lbs. Just don't overload max. tong weight, need some room for safety!
This adapter design was exactly what I was looking for. I often carry 4 or more bikes with my Sylvan GO. The pictures show how I configured my setup. Its perfect!!! And yes, I have to be a little careful on really tight turns but its never been an issue. Thank you George and the etrailer team.
# 5
Curt Trailer Hitch Receiver Adapter - 1-1/4" (Class II) to 2" - 6" Long
The Curt C45785 1.25 inch to 2 inch hitch adapter seems well-constructed, but does NOT fit the current SPA Volvo OEM 1.25 inch automatic retractable hitch receptacle (mine is on a 2020 V60 Cross country). The lock pin hole doesn't go back far enough to accommodate the pin -- see photo.
Great product from an even greater company. ETRAILER has the knowledge and products to solve most any trailering problem.
# 6
CR Brophy Hitch Extender for 1-1/4" Hitch Receivers - 5-3/4" Long
Here in Saskatoon, Canada, I am very pleased to endorse J&J's flagpole holder and hitch mount extension products. Solid construction and beautifully finished engineered pieces. Fitted easily onto my '92 Camaro RS, for Shriner parades. Supporting a worthy philanthropic effort for children.
1 1/4" extension fit well (could be a tiny more snug). but was just what i needed for my mini cooper and new bike rack. Fast Ship good price and I would use them again. Now i can use my bike rack! :)
# 7
MaxxTow Trailer Hitch Receiver Adapter - 2" to 1-1/4" Hitch - 11" Long
Installed my 2” hitch but don’t have a 2” bike trailer yet. I purchased this to continue to use my 1.25” bike trailer (until I find a deal). Used this over Thanksgiving weekend on I35 in Texas (tons of traffic)and I’m very pleased with the performance. I’m was secure and bikes traveled just fine.
I ordered this adapter from e-Trailer so I could extend my bike rack past my spare tire on my 2005 Honda CRV. This solved my problem and this thing is well made to take the weight. I'm glad I purchased from e-trailer because I know now that they sell quality products as I have also purchased a new receiver, ball mount and 2' ball to pull my trailer. If your goal is quality, great service and fast shipping then e-Trailer is one company to go with.
# 8
Roadmaster Dual Hitch Receiver Adapter, 2" or 10" Drop/Rise
I love the product not just for the obvious reasons such as it’s extremely durable and well made for safety but specifically for length of the arm. The arm length is just long enough to clear my hitch rack walls, which allowed me to plug in my bike rack. I would certainly recommend this product to others. I haven’t seen any marketing for this specific use case so have at it.
I’ve been using this product every day for over a year at this point. On the back of our Class C RV it supports a bike rack carrying 3 bikes (one is a heavy eBike) and a Roadmaster tow bar, which connects to a Jeep Wrangler when we travel. It provides the need height for the bike rack and the drop needed for the tow bar to be level with front of the Jeep. We are full time RVers, so it gets a lot of use. It has worked perfectly and remains in new condition.
# 9
Roadmaster Dual Hitch Receiver Adapter, 2 " or 8" Drop/Rise
Perfect for my application.
Works great! I use it on my motorhome to carry my bikes with a Rocky Mounts Carrier and flat tow my car with my Blue Ox system. It places the bike carrier at an optimal height over the front of the car but my may be different for other bike carriers. Very sturdy and seems to be quality all around.
# 10
Hitch Adapter 1-1/4" to 2" Trailer Hitch Receiver (Class II Only)
This adapter allows us to use a bike rack we have across all our cars. It is perfect for light duty applications, easy to use and it can be stored in the trunk until you need it. I would definitely recommend it.
I was concerned that the adapter might not fit on my 2023 Toyota Venza, LE, but it fits just fine. So, the notice that the adapter will not fit a class one hitch does not apply to the Venza, even though the Venza specifications indicates it is a class one hitch.
# 11
Malone 2" Dual Purpose Hitch Receiver
Used the Malone 2" Dual Purpose Hitch Receiver to have a bike rack with two bikes on the upper Receiver and a 21' bassboat on the lower Receiver. Ran down to Florida Everglades, Florida Keys and back home. Almost exactly 4,000 miles. Hitch worked perfectly. I did find that you can not "jacknife" the boat as much or the bow of the boat will touch the bikes on the rack but that is to be expected. Hitch was quiet, strong and exceeded my expectations. Easy to install and looking forward to using it again in a month for another 4,000 mile road trip. Note: I drive fast and the roads are not always perfect. This is a sturdy Hitch Receiver. Hope this review helps you. Sorry, crummy photo as the Receiver is a "set it and forget it" product. Be well.
I bought this Dual Purpose Receiver at Twice the price of that Big online company because of reviews from owners that bought on both sites. After evaluating the reviews, I chose to go with etrailer because I have come to trust them as a company that gives you a great product that they will stand behind and they appreciate your business. I haven’t used this receiver yet, but can look at it and I am comfortable that I made the right choice. I will follow up with another review after I use it.
# 12
Hitch Extender For 1-1/4" Trailer Hitch Receiver 10"
I recently had a hitch installed on my car. Since the cargo carrier that I have was used previously without an adapter, I assumed that I didn't need one. Now trying to locate one was more of an effort than locating a hitch. The local auto parts stores of national brands don't keep them in stock. One store made an inquiry but didn't give me much hope. Now I can make a rode trip in confidence that the carrier will be secure as I head down the interstate.
Quality product and excellent service from etrailer.com! The Hitch Extender works well allowing me to back my boat trailer further into the deeper water.
# 13
TorkLift SuperTruss Hitch Extension for SuperHitch Trailer Hitch Receivers - 36" Long
I think it is a great product but expensive. In retrospect I could not do what I wanted with the truck and hitch so I spent the money needlessly. Not any fault of your company. I would have been just as well to leave the stock OEM and not spent the money anyway. Live and learn.
The larger of two packages arrived with the actual smaller Torqlift box inside. All expected parts were delivered. The upper tube fit fine. The lower tube was very tight. I first removed some of the paint near the end of the tub with little success. I have the 20k Original Torqlift hitch. I decided to file the inside of the lower receiver and this smoothed out the problem. Then I found that the two stabilizing chains were four links two long for my application. I cut them shorter and PERFECTION! I provided the detail as realistic, but minor issues happened. As shown in the photo, the 36" extension looks very solid and I'm perfectly satisfied.
# 14
TorkLift Cannon Hitch Extension - 3" Ford Super Duty Factory Hitch - 42" Long
Just got it this afternoon and removed my old oneand installed this new one. The box was in bad shape from trip, but the hitch extension and accessories were all there and in good shape. Looks like a much better setup than I had. Thanks for a good product and great service. Not very common these days, but greatly appreciated!
She's boxy...and a little heavy...but she's good! If using with a truck camper, save your back and put it on before the camper goes in the bed.
# 15
Titan Hitch Box Extension for 2-1/2" Trailer Hitches, 41" - 48" Long
Just received the 41/48 inch hitch extension today so haven’t actually used it. However, one can tell the high quality by looking at the welds and thick paint coating. This item is extremely heavy. I expected some weight to it, but it surprised me. Also, the tubing has very tight tolerances. I have two ball mounts, neither of which slid into the extension on their own. I had to pound them in and tap them out with a 3 pound hammer. Once paint and labels were scraped away by this action the ball mounts were able to be slid in by hand. This extension will be used on my dually carrying my truck camper. I’ll be towing an aluminum trailer with a Can Am Spyder. Total weight towed will be less than 2000 pounds so I don’t expect the extension to be subjected to any stress.
As per my last 3 orders here are some pictures of how I received the item along with what was broke or bent. I can fix it but I shouldn’t have to. So I will try elsewhere from now on cant deal with your shipping dept , anymore.
# 16
Saris Swing Away Hitch Extender for Bike Racks - 2" Hitches
Already have a Sris bike rack, has been an excellent rack and well be compatible with this hitch, both very well built
Love it! It swings out of the way so I can get the back door open. The other advantage is it allows the back door to be open a few inches at night (when the hitch is in the locked position) for airflow when it’s hot.
What our customers are saying:
"Quick processing, and delivery. reasonably priced very satisfied"