# 1
Hitch Adapter 1-1/4" to 2" Trailer Hitch Receiver
Very heavy duty. Will use it with a bike rack I had for another vehicle that had a 2" receiver.
# 2
Hitch Adapter 1-1/4" to 2" Trailer Hitch Receiver with 5" Rise
So far, so good. Had to cut into the bumper if my 2011 Jetta in oder to make it work. Here is a picture.
The item was very well built and arrived quickly. The only complaint I have, is a problem I was expecting to have after reading another review, so I don't feel cheated, just a little disappointed: it doesn't really fit a 2013 Jetta Sportswagen with a U-haul branded hitch. It doesn't clear the bumper. The male part the goes into the receiver needs to be just about 1.75" longer (2.00" might be better) to clear the bumper. A suggestion would be to make the male appendage 2" longer and provide two holes so people can use either the shorter or longer extension, depending on how far out they need to go to clear the bumper. (I was able to make it work by chopping off a triangular part off the top part of the unit)
# 3
Curt Hitch Extender for 1-1/4" Trailer Hitch Receivers - 7" Long
Perfect fit to extend the hitch to allow my bike rack to clear the back bumper. Great quality as well.
This hitch extension was exactly what I needed. New hitch on the Toyota Avalon has the receiver box a little too far under the bumper to fit my bike carrier. The diagonal support on the carrier didn't allow hitch pins to align without modifying (cutting) bumper. This extension was a simple yet effective solution to moving the carrier away from rear of vehicle. (Photos were taken without hitch pin in place) The item was in stock and shipped rapidly. Thank you etrailer.
# 4
Roadmaster Dual Hitch Receiver Adapter with 2" or 6" Drop/Rise
Worked out great for my family bike adventure. Traveled with that setup over 1000 miles and it was easy drive. I had cargo carrier on the bottom and bike rack on top, and with that setup and 4 people on board still plenty of ground clearance 11". Dual hitch is a solid piece of steel that can carry a lot of lbs. Just don't overload max. tong weight, need some room for safety!
This adapter design was exactly what I was looking for. I often carry 4 or more bikes with my Sylvan GO. The pictures show how I configured my setup. Its perfect!!! And yes, I have to be a little careful on really tight turns but its never been an issue. Thank you George and the etrailer team.
# 5
Curt Trailer Hitch Receiver Adapter - 1-1/4" (Class II) to 2" - 6" Long
The Curt C45785 1.25 inch to 2 inch hitch adapter seems well-constructed, but does NOT fit the current SPA Volvo OEM 1.25 inch automatic retractable hitch receptacle (mine is on a 2020 V60 Cross country). The lock pin hole doesn't go back far enough to accommodate the pin -- see photo.
Great product from an even greater company. ETRAILER has the knowledge and products to solve most any trailering problem.
# 6
CR Brophy Hitch Extender for 1-1/4" Hitch Receivers - 5-3/4" Long
Here in Saskatoon, Canada, I am very pleased to endorse J&J's flagpole holder and hitch mount extension products. Solid construction and beautifully finished engineered pieces. Fitted easily onto my '92 Camaro RS, for Shriner parades. Supporting a worthy philanthropic effort for children.
1 1/4" extension fit well (could be a tiny more snug). but was just what i needed for my mini cooper and new bike rack. Fast Ship good price and I would use them again. Now i can use my bike rack! :)
# 7
MaxxTow Trailer Hitch Receiver Adapter - 2" to 1-1/4" Hitch - 11" Long
Installed my 2” hitch but don’t have a 2” bike trailer yet. I purchased this to continue to use my 1.25” bike trailer (until I find a deal). Used this over Thanksgiving weekend on I35 in Texas (tons of traffic)and I’m very pleased with the performance. I’m was secure and bikes traveled just fine.
I ordered this adapter from e-Trailer so I could extend my bike rack past my spare tire on my 2005 Honda CRV. This solved my problem and this thing is well made to take the weight. I'm glad I purchased from e-trailer because I know now that they sell quality products as I have also purchased a new receiver, ball mount and 2' ball to pull my trailer. If your goal is quality, great service and fast shipping then e-Trailer is one company to go with.
# 8
Roadmaster Dual Hitch Receiver Adapter, 2" or 10" Drop/Rise
I love the product not just for the obvious reasons such as it’s extremely durable and well made for safety but specifically for length of the arm. The arm length is just long enough to clear my hitch rack walls, which allowed me to plug in my bike rack. I would certainly recommend this product to others. I haven’t seen any marketing for this specific use case so have at it.
I’ve been using this product every day for over a year at this point. On the back of our Class C RV it supports a bike rack carrying 3 bikes (one is a heavy eBike) and a Roadmaster tow bar, which connects to a Jeep Wrangler when we travel. It provides the need height for the bike rack and the drop needed for the tow bar to be level with front of the Jeep. We are full time RVers, so it gets a lot of use. It has worked perfectly and remains in new condition.
# 9
Roadmaster Dual Hitch Receiver Adapter, 2 " or 8" Drop/Rise
Perfect for my application.
Works great! I use it on my motorhome to carry my bikes with a Rocky Mounts Carrier and flat tow my car with my Blue Ox system. It places the bike carrier at an optimal height over the front of the car but my may be different for other bike carriers. Very sturdy and seems to be quality all around.
# 10
Draw-Tite Hitch Extender for 2" Hitch Receivers - 18" Long
I was surprised by just how solid and heavy it was made. Just what I needed to move my Bobcat UTV hitch back to I can use it as my yard dog to shift my trailers around and not worry about the plastic tailgate nor the plastic bed getting damaged. The hitch sits under the bed and this extends it out so it is useable.
The hitch extension worked perfect. The only one that was 18" pin to pin which was exacty what I needed to make this combo work. Dual hitch to start. Top whole a luggage rack to haul coolers and the bottom for the bike rack. Thanks etrailer.
# 11
Malone 2" Dual Purpose Hitch Receiver
Used the Malone 2" Dual Purpose Hitch Receiver to have a bike rack with two bikes on the upper Receiver and a 21' bassboat on the lower Receiver. Ran down to Florida Everglades, Florida Keys and back home. Almost exactly 4,000 miles. Hitch worked perfectly. I did find that you can not "jacknife" the boat as much or the bow of the boat will touch the bikes on the rack but that is to be expected. Hitch was quiet, strong and exceeded my expectations. Easy to install and looking forward to using it again in a month for another 4,000 mile road trip. Note: I drive fast and the roads are not always perfect. This is a sturdy Hitch Receiver. Hope this review helps you. Sorry, crummy photo as the Receiver is a "set it and forget it" product. Be well.
I bought this Dual Purpose Receiver at Twice the price of that Big online company because of reviews from owners that bought on both sites. After evaluating the reviews, I chose to go with etrailer because I have come to trust them as a company that gives you a great product that they will stand behind and they appreciate your business. I haven’t used this receiver yet, but can look at it and I am comfortable that I made the right choice. I will follow up with another review after I use it.
# 12
Hitch Extender For 1-1/4" Trailer Hitch Receiver 10"
I recently had a hitch installed on my car. Since the cargo carrier that I have was used previously without an adapter, I assumed that I didn't need one. Now trying to locate one was more of an effort than locating a hitch. The local auto parts stores of national brands don't keep them in stock. One store made an inquiry but didn't give me much hope. Now I can make a rode trip in confidence that the carrier will be secure as I head down the interstate.
Quality product and excellent service from etrailer.com! The Hitch Extender works well allowing me to back my boat trailer further into the deeper water.
# 13
Trailer Hitch Adapter - 1-1/4" to 2" Hitch - 4-1/2" Drop/5" Rise - 6-1/2" L
Perfect and simple item. It was easy to install. I purchased an accessory with receiver opening of 2” and my jeep had 1 1/4 receiver.
I love it! It’s allowed me to use a 2 inch bike rack on the back of my sedan in a safe manner.
# 14
Hitch Reducer 2" to 1-1/4" Trailer Hitch Receiver
This has worked great to reduce my 2" hitch so that I can continue to use my 1 1/4" Thule bike rack, and I like that it doesn't extend out much from the hitch. After my last trip though, the inset separated from the larger piece. I can still use it, but without the smaller piece fixed in place, I can't put it on the car first and then slide the bike rack into it since the smaller piece slides, and it's impossible to line the holes up. It's also rusted more than I expected. It wasn't inexpensive, and I was hoping it would last longer. I've used it for maybe a dozen trips.
Perfect fit BUT the inner tube broke away from the outer tube after about a dozen trips. One small weld on the outside corner is all that holds it on. The small amount of play must have been too much for it. I was even using an anti-rattle lock pin. Very disappointing due to the price point. And now it’s unsafe to use as it could slip right out of the receiver.
# 15
Titan Hitch Box Extension for 2-1/2" Trailer Hitches, 41" - 48" Long
Just received the 41/48 inch hitch extension today so haven’t actually used it. However, one can tell the high quality by looking at the welds and thick paint coating. This item is extremely heavy. I expected some weight to it, but it surprised me. Also, the tubing has very tight tolerances. I have two ball mounts, neither of which slid into the extension on their own. I had to pound them in and tap them out with a 3 pound hammer. Once paint and labels were scraped away by this action the ball mounts were able to be slid in by hand. This extension will be used on my dually carrying my truck camper. I’ll be towing an aluminum trailer with a Can Am Spyder. Total weight towed will be less than 2000 pounds so I don’t expect the extension to be subjected to any stress.
As per my last 3 orders here are some pictures of how I received the item along with what was broke or bent. I can fix it but I shouldn’t have to. So I will try elsewhere from now on cant deal with your shipping dept , anymore.
# 16
Saris Swing Away Hitch Extender for Bike Racks - 2" Hitches
Already have a Sris bike rack, has been an excellent rack and well be compatible with this hitch, both very well built
Love it! It swings out of the way so I can get the back door open. The other advantage is it allows the back door to be open a few inches at night (when the hitch is in the locked position) for airflow when it’s hot.
What our customers are saying:
"I received this order yesterday. Thanks for the outstanding service. I appreciate it! Thanks, Alex"