Be seen with this 3/4" round red LED light for clearance or side marking. Mounted in a UV-resistant bracket for easy installation on flat surfaces. Quick wiring with an 8", stripped, 2-wire pigtail - just connect and go. PC rated.
The corrosion-resistant, gray polymer bracket makes installation easy on flat surfaces - no recessed hole required. The included rubber grommet holds the LED light firmly in place, while the 8", stripped, 2-wire pigtail makes wiring easy. No complicated setup - just mount, connect, and go. Works with 12V systems.
Built to handle wet conditions, this light features a sealed, waterproof housing that protects against rain, road spray, and full submersion. Whether you're towing through storms or launching a boat, you won't have to worry about water damage shortening the life of your lights.
Also known as bullet lights, these compact LEDs are popular for more than just visibility. Used in multiples, they help keep your trailer street legal while adding a custom look. Whether lining your trailer, truck, or RV, they provide both function and style.
A PC-rated light produces a 90-degree angle of light to either side of its centerline for a total of 180 degrees of coverage. This beam pattern makes the light visible from the front and both sides, enhancing visibility and safety. When properly installed, it functions as both a front clearance light and a side marker light or as a rear clearance light and a side marker light.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi, everyone. Steve here with etrailer.com. Today we're looking together at our LED Clearance Side Marker Light with a nice rectangular bracket. It's submergable with one diode. Folks, as you can see, it's red. Has a nice round red LED there.
And again, you have this wedge rectangle bracket here. I'm calling it a wedge. It's basically like a half circle kind of deal. And again, it is rectangular across the back. You have two mounting holes.
Those are three inches apart, center to center. Overall, though the whole housing itself is three and 15-16th inches long, one and five-eighth tall by about one and 15-16th inches deep. The LED light is three-quarter inches diameter by 13-16th of an inch tall. Let's go ahead and shut off the overhead light so you can see this a little better in the dark. So, as you can see, very nice, vibrant.
It's small but bright, right So LEDs, we know they last longer, they're brighter. They're gonna actually add visibility without up space being this small and this bright. This is a high strength UV resistant gray polymer (hand tapping) as far as the bracket itself. And it's waterproof, so this whole system's been sealed up, so you're not gonna have to worry about water, anything like that. You can put 'em on boat trailers, submerge 'em if you need to, and everything's gonna be fine.
Two wires, black and white, very simple to run. It runs on nine to 16 volts, making it great for 12 volt systems. And once again, it is PC-rated and that just means you can see better peripheral, top bottom, easier to spot this on all angles, so it's a very nice, safe light as well. Folks, that's gonna wrap it up for our look together. I'm Steven. Thanks for your time. Thanks for watching. Have a good one!.
Ratings & Reviews
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.