Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
When you’re running three axles, uneven roads can make the ride harsh if your suspension isn’t balanced. This kit uses four 10-1/8" long, swan-shaped equalizers that work between the leaf springs to spread out bumps and dips. That keeps all three axles sharing the load so your trailer stays steady and smooth even when the pavement doesn’t.
Heavier rigs need suspension parts that can take the strain. This setup is made for triple-axle trailers rated from 3,500 lbs up to 8,000 lbs per axle. It gives you the right hangers and equalizers to handle serious weight without sagging or flexing where it shouldn’t.
Every frame is a little different, and this kit lets you place the hangers where they need to go. The front, center, and rear spring mounts can be welded along the frame wherever spacing works best for your layout. You can set it up for about 28-1/2" from first to second hangers, 33" between centers, and another 28-1/2" to the next—right in line with a 33" axle-to-axle distance when using these 10-1/8" equalizers.
Getting all the right pieces together makes installation easier. This kit includes (2) 4-1/4" tall front hangers, (4) 3-1/2" tall center hangers, (2) 5-1/4" tall rear hangers, plus wet bolts, shackle bolts, keeper bolts, and matching locknuts. You’ll have everything needed to hang six 2" wide slipper springs (sold separately) so the suspension lines up solid from front to back.
No special angle measurements are required for these swan equalizers. Once installed hand-tight with the springs in place, everything settles into position naturally before you torque it down. That means less trial and error when mocking up your suspension and a cleaner fit when you’re done welding it in place.
Customer Satisfaction Score:
98% were satisfied with this product
2% of customers were not satisfied
Ratings & Reviews

Jenny N.
5/30/2023
It looks like we had responded a couple of times so I am not sure as to what happened. Sometimes GMAIL will read our emails as spam so may have moved our responses to the spam folder. I do not have a drawing that I can send however the spacing you are looking for between the hangers for the Triple-Axle Trailer Hanger Kit for 2 inch Slipper Springs part # AP302-H302 is 28.50 inches for the first to second hangers, 33 inches from the second to third hangers, and then 28.50 inches from the third to the fourth hangers. This would allow you to use a 2-inch slipper spring like the 5-Leaf for 7K Axle part # SP-232275. When it comes to exact placement of the hangers on the trailer frame thats something you will have to play with to get the correct placement. The ideal locations will give your trailer a tongue weight thats 10-15 percent of the weight of the trailer. I have included an article that will help.
Helpful Links
Do you have a question about this Trailer Suspension Part?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.








Frictionman
7/4/2014
This kit is for 3500lb to 8000lb capacity range. Too many spring possibilities to include bushings. Shop for your specific bushing needs on this site.