Dimensions of Equalizer in Triple Axle Slipper Spring Hanger Kit AP302-H302
Updated 09/18/2018 | Published 09/17/2018
Question:
on the equilizers, from what point do you measure to determine the length? you list the equilizers in this kit to be 10 1/8 inch long. Is this from bolt hole to bolt hole or overall length?
asked by: George
0
Expert Reply:
Yes, trailer suspension equalizers are measured from hole center to hole center. The 10-1/8-inch dimension provided for the swan-shaped equalizers in kit # AP302-H302 is from the two outside holes as shown in the linked image.
expert reply by:
Adam R
0
click to enlarge
Product Page this Question was Asked From
Triple-Axle Trailer Hanger Kit for 2" Slipper Springs - 10-1/8" Long Equalizers
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Slipper Springs - 2 Inch
- Triple Axle
- Redline
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Is There a Replacement Hub/Drum For Dexter 8-283?
- Q&A: Replacement for Dexter 8-283 Hub/Drum
- Q&A: How to Determine Correct Replacement Slipper Springs for Triple Axle Trailer With 8,000 lb Axles
- Q&A: Redline Triple-Axle Slipper Springs Equalizer Spacing
- Q&A: Awning Replacement For Sunchaser Awning Model # 834AV17.401
- Q&A: Hanger Spacing with Triple Axle Hanger Kit AP302-H302
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: How to Determine Hanger Spacing for Tandem Axle Trailer Suspension with 26 Inch Springs
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Where to Position the Trailer Axle?
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Accurately Measure Trailer Leaf Springs