To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
This sleek, aerodynamic roof rack provides space to carry gear on your vehicle. Crossbars with push-down rubber strips in top channels work with channel-mount and clamp-on accessories. Installs on your vehicle's naked roof.
Features:
Specs:
Alternate Instructions
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today on our 2014 Honda CRV we are going to be test fitting the inno roof rack system. This is going to be consisting of part numbers INXB108-2. Those are going to be the crossbars. Part number INXS200, those are going to be the flush feet. Part number INK413 and that's going to be the clamp that holds it onto your vehicle. We already have the front one installed. You can see it has a nice shape to it.
It looks like it's part of the vehicle. It has a nice aero-dynamic shape which will cut down on wind noise and drag. Let's go ahead and show you how the rear one installs. We already have it partially assembled on our table here. Let's flip it upside down here. The first thing that we're going to do is slide out this portion here on the side of the arm.
Then we will take our mounting plate and put it into position. You will see that it has a little indentation here at the bottom. That's going to fit into the indentation in our little bracket here. Push that back in and then we will load up our foot. This portion here is going to insert into this area here on our bar. Then we will just slide back a little bit and you're going to look into the instructions, because you want a specific measurement in between each foot.
It is going to be different for both the front and the rear. Once we've got it set to where we need it. We'll take the included allen key, go to the bolt on the inside here and tighten that down in place. Then we will take our foot pad and we will install that as well. That just pushes into position. I'm going to flip this around so you can see it a little bit better.
We will remove this screw at the end, then install our clamp. You just want to get it loosely installed so it stays in place. With that done, we can actually set it onto our vehicle. I'm going to go ahead and open up the two rear doors. Then we will set it on. Be careful not to scratch the roof when you do this. If you are a little nervous that you will, just grab an extra set of hands and that will help you out. Now the next thing I'm going to do is get a measurement for the crossbar spread. That's going to be from the center of the front door jam to the center of our bar. Now let's go to the other side and repeat the same process. That looks good. Now we're just going to double check our first measurement, then we can start tightening it down. Now it also comes with the included tool to tighten this down. First we're just going to snug it up right along this edge here. We will do this on both sides and then we'll tighten it down completely. Once we have it snug, give it five or six turns on both sides to make sure we tighten this down evenly. That's not going anywhere. Now we'll take our covers and place those on and lock them up. With that we have installed our inno roof rack system for our 2014 Honda CRV.
Do you have a question about this Roof Rack?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.