Best 2002 Toyota Sienna Trailer Hitch Ball Mounts

Retail type stores only carry mainstream items so when I needed a special length ball mount for my 2011 Traverse I found the size and quality with Curt Products .

Recently bought a Kubota RTV x900. The receiver is located under the bed. With the extra long ball hitch drawbar I can easily get to the drawbar and use a clevis to hitch my 5ft. wide mower or attach a ball and use the trailer. The pictures will illustrate the length of the drawbar which makes access very easy. The product is heavy duty and well made. Ordered this product on Thursday morning and it was delivered the next day, Friday afternoon. Customer service was helpful, will use etrailer again. Thanks

I bought a hitch, stinger, ball and wiring harness for my 2004 Toyota Sienna. It was delivered fast, it was the right stuff, and it fit, just like it was supposed to. It really was as easy to install as it looked in your video. The video was immensely helpful too. The video showed me exactly what I needed to know to get my hitch installed correctly and it gave me the confidence to order online and do it myself. The only drawback is a loss of ground clearance but you warned me fair and square up front about that, so I can hardly complain. Thank you, that was a good investment.

I ordered this for my 2013 Toyota Sienna SE. I was a little nervous as the frame mounted hitch is low and tucked back in on my van but this thing fit perfect in the upturned position. It also gave me the perfect distance from the ground for my two trailers that I tow. Very heavy duty item and it fits well in the receiver. Ordered on a Sunday and received on a Wednesday - so very happy with the service.

I hooked up the draw bar today for the first time to the trailer that I built and the hitch I installed. The draw bar uses a cotter pin that slides on the bolt rather than going through a hole to mount the bar to the hitch. I have never used a sliding on pin in anything - I've only used those that go through a small hole matching the pin. This includes my farm tractor and other tools. I hope it is secure because it does slide on easily. The bar itself appears nice and strong.

We used our car hitch and cargo carrier last summer in a Honda Accord to support a cargo carrier. It held up great on a 4,000 mile camping/hiking trip from Mid Missouri to Glacier National Park, MT. We were able to use the carrier/hitch to carry our large tents and baggage (approx 120#)directly behind our car trunk. Initially I was a little hesitant at the smaller 1-1/4" tube hitch, but it was very stable throughout the long trip. Sure was a lot less drag than putting all our gear on a roof cargo carrier.

The ball mount is just what I needed but I think the packaging could have been stronger. One end was ripped open.

Basically I bought this ball-mount after I installed the low-slung hitch receiver from ETRAILER to know I have an ability to haul something if really needed in an emergency situation. The receiver hitch was purchased for my Thule bicycle rack , purchased from Etrailer.

fits like a glove. works perfectly

I wasn't sure what type of ball mount I needed for my new Mazda CX-9, so I had to call a representative. The first time I called, the very knowledgeable gentlemen told me exactly how to measure my SUV to figure out the drop I needed. I called back the next day and talked to a lady who helped me figure out exactly what I needed. This is my second purchase from etrailer. The first was a hitch for my old Honda Odyssey, which was also a great experience. The employees are so helpful, the video tutorials on the web site are fantastic and the prices are great. etrailer.com is the first place I go to look for trailer and towing supplies!

Very pleased with etrailer. Very easy to order from website. Fast delivery, easy to install ,perfect fit . Thanks. .

Perfect fit for 2 inch Draw Tite receiver. good price, fast shipping.

Needed this to use with a Valley hitch mount bike rack on my Sienna, which ball mounts from Uhaul weren't long enough. This certainly is. I am extremely happy with it and the fast delivery even though I had opted for cheapie shipping.

Very happy with this ball mount - provides just the amount of drop we required for a level tow of our GeoPro travel trailer by our RAM2500. Plus, the extra length not only allows a tighter turning radius, but also allows us to lower the truck tailgate without having to detach the trailer. Huge improvement on all accounts for us compared to our prior setup. The product is well built and I'm confident will provide us years of good use.

I neeed to pull a trailer with my 2019 GMC Yukon. I found Etrailer.com and followed the instructions on determining the drop of the hitch, the instructions were spot on. I hooked up my trailer to my Yukon today, all was level and worked perfectly. I had driven around to Napa, Lowe’s, Home Depot and Walmart, and nobody had the 9” drop hitch I needed. Came back to Etrailer, bought the 2” ball and pin, and the Curt 9” drop hitch. I received the items quickly. Great website, Thanks, Craig

The quality of this product is fantastic and it assembled with no problems and makes my rv / toad I pull a perfect match. I will continue to do business with (etrailer.com) much more in the future. The following photos are of my 1988 Fleetwood Jamboree and my baby (rare 1982 Toyota Corolla Station Wagon) all connected up and the 9" drop towing bar makes my Toyota towing very easy and safe at a level condition with my RV. Also look at the new LED lights installed to dress up my older RV, also purchased from Etrailer.com. I am a happy camper and highly recommend purchasing from them.

Plugged right in. Worked great on my 2008 Toyota Sienna Van. Great information on correct size. Easy. Thanks

Flipped it for hight on a Toyota Sienna 2015 - Works Great!

This is exactly what was needed - we are pulling an 800 lb., single-axle lawn trailer and this setup is working very well. Installation took one afternoon and we were up and working the next day. THANK YOU!

Using this on my 2004 Toyota Sienna. Clears the bumper just fine and I like the easy functionality of changing the ball size. Sturdy construction!

etrailer shipped fast and had great communication. The hitch was built very well look like a quality product and was just what I needed. The 5 inch rise was perfect for our 2009 Toyota sienna.

Paint on draw bar was a little questionable. But it came that way from the manufacturer! Had nothing to do with Etrailer quality of service!

Love the ball mount. I have a Toyota Sienna and the rear seats recess into a well, therefore the receiver hitch much go underneath the well. This means the ball mount enters the receiver approximately 10 inches off the ground. By using the ball mount to raise the ball, this makes the ball around 22 inches off the ground, which is recommended height for my trailer. My only regret is that I did not request you attach a ball as I did not have any wrenches large enough to fasten it. Again, the mount is great. Thanks, Ron Baker

Prompt delivery, looks great.

Wasn't sure if this is going to work on our 2009 Toyota sienna, but it's just right. The 5 1/2 inch height was perfect for a double axle ATV trailer. Item is quality made and etrailer shipped fast!

Received the Class II Drawbar 5-1/2" Rise or 6" Drop - BM96 in a timely manner. The rise was what I was looking for to use with my Polaris ATV 570 since its standard receiver is 1-1\4 hitch and sits low to the ground. This was just the right height to pull my john boat behind the ATV.

Fits our VW Touareg perfectly and allows us to tow a variety of things now. As can be seen in the pictures the hitch has a +5-inch gap between the bumper and the vertical adjustment pillar and the trailer itself is out further so there's enough room to get to the rear hatch and maneuver the vehicle/trailer.

I needed a hitch that I could haul my work trailer with and still drop the tailgate without dropping the trailer. I looked on etrailer and found one that would work barely but decided to call etrailer and see if anyone had any ideas. Steve answered and looked after I told him my requirements and came up with this. This has a longer distance from ball to pin by a few inches compared to the one I found so my tailgate will still drop even if I’m at an angle to my trailer or on a hill. Also with the adjustable height it’s great. Awesome hitch. Solid for a good price. ??

Thanks, Etrailer! The Ball Mount information is very helpful. This package works for my 2004 Sienna. Fast shipping. Happy with shopping experience!

Excellent Web site, easy to navigate, great prices, easy purchase experience, fast delivery. I had someone install the hitch - all good, looks great - no photo, but take my word - it looks great on my 2003 Buick Rendezvous. An easy, "Five Star" rating (Web sales experience and hitch).

The information and resources on your web page are truly outstanding :) It made ordering the right products seamless. Order executed and products received i.e. one happy customer........ Remarkable

As advertised and what I needed thanks.

The hitch on my Sienna is mounted low and recessed under the bumper so this ball mount has been perfect for the right height and reach for my boat trailer to ride level. etrailer is the only place I found what I needed. Actually I always look there first because they have such a good selection.

The ball mount dimensions and quality were as advertised. Shipping was extremely fast, to Hawai'i! Very satisfied with this purchase.

Fast shipping! Very nice product! Great customer sevice! Highly recommend! Thank you!!!

Was needing a 7-8 inch ride for my camper that could sustain a GVW of at least 5000 lbs. Let me say, it’s a hard to find item. Thankfully I called Etraer and with some research, found me the perfect ball mount. It’s heavy duty for a reasonable price.

This is a great all-purpose hitch. I've used it to mount a heavy-duty bike rack and a steel T-rack to carry a canoe as well as lumber. Most recently I hauled 5 x 8 cargo trailers full of plants, then furniture for a 600-mile move. It was simple to use, problem free, very strong and sturdy. Now that I live on some acreage, I see a trailer in my future, so this will get a lot more use. I drive a 2013 Tacoma, so this is a good size hitch at a good price with sufficient capacity for my needs. I do use a key lock for the hitch as well.

I actually got my hitch the date they said it would be here to my surprise. When the box arrived it was pretty much beat up, not the hitch just the box. I wished there was instructions how to install it. Overall very satisfied and will buy from 5hem again

I bought the Curt D210 Multipurpose Ball mount to raise the level of a Kuat platform bike rack with extender for 4 bikes from my Drawtite hitch on a 2007 Toyota Sienna. Service from eTrailer was superb, the mount is extremely well-built, and it fits my Sienna/hitch like a glove. We used the rack with 4 road bikes on two trips this week-end and it worked flawlessly; not even a minor scrape through many driveways and turn-ins. The system does move the rack back a few inches; 50.5" from the bumper, so we needed a red flag on the end (at least in MO). This is the only nit in an otherwise great product.

We sold our small motor home and purchased a small travel trailer. This hitch provided a perfect solution to how to use our bike rack while towing the trailer. It even allows room for the pickup tailgate to be lowered without removing the bikes from the rack. The hitch is very hefty with a high weight limit - plenty for the GVW of the trailer (7,000#) plus 125# of rack and bikes.