Transmission Cooler Recommendation for a 2008 Cadillac Escalade 6.2 Liter

Question

Question:

I have an 08 Cadillac Escalade with a 6.2 liter my concerns on towing7500 pounds short distance but extreme high heat area.

asked by: Jeff

0

Expert Reply:

Considering the weight of your trailer (7,500 pounds) I recommend going with a slightly larger cooler, # D13504, which will provide more cooling than a smaller model. Since transmission fluid cannot be overcooled we usually recommend going with larger coolers. I have included a link to a video showing an example installation for you.

expert reply by: Michael H

0

Answer 1

Direction of flow won't matter if you are planning to bypass your factory cooler with an aftermarket one like the part #D13504 that you referenced. Coolers like this are not directional so as long as you attach both lines to this cooler it will…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 6

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

view full answer...

Answer 7

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Transmission Cooler Recommendation for a 2008 Cadillac Escalade 6.2 Liter

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching