Can an AWD 2015 Ford Edge be Flat Towed Behind a Motorhome
Question:
Can I tow the above car behind my Country Coach at Interstate speeds in Texas for a full day?
asked by: Stan S
Expert Reply:
I did some research on your 2015 Ford Edge and it looks like as long as you have a V6 engine in your AWD Edge you can flat tow it without any speed or distance restrictions. Ford does recommend starting the car and letting it idle for at least 5 minutes for every 6 hours of flat towing though. You will need to consult the owners manual for full procedures.
For a base plate kit you will need the part # RM-524444-5.
In addition to the base plates, you will also need a compatible tow bar, safety cables, lighting, and supplemental braking to flat tow your vehicle. The most popular compatible tow bar is the Falcon 2, # RM-520. For safety cables you can use # RM-643. The coiled design helps keep the cables off of the ground.
For lighting you can use the diode kit # RM-152 and not have to cut into the taillight assemblies. You will also want the # BX88206 to connect this lighting solution to your tow vehicle. This comes with a round 6-way connector that you will install on the front of your towed vehicle and enough coiled wire to go from there to the RV.
Dinghy wiring the 2015 Ford Edge SEL model is quite a bit different than normal diode wiring because Ford combined the stop, turn and taillight signal on the same wire that goes to the rear facing LEDs in the taillight.
To make the # RM-152 kit diodes work properly you will need 2 resistors rated for 50 ohms and 10 watts for LED tail lights or 2 rated for 5 ohms and 10 watts for incandescent tail lights, available from a local electronics supply store. You will also need to wire the diodes differently to get the LED taillights to work properly. I have attached a diagram showing how to wire in the resistors and the diodes.
We did a flat tow setup on a 2015 Ford Edge SEL here and found that the correct wire to splice into was the darker brown wire which is most likely the same wire you used that only illuminated the side marker lights in the rear taillight housing. Using this new diagram you will get the rear taillights to work properly.
And finally, most states now require supplemental braking in the vehicle being flat towed. The easiest system to set up and use is the Blue Ox Patriot # BRK2016, that applies the vehicle brakes in proportion to how much the tow vehicle is braking. This is the safest way to stop and it reduces wear and tear on both vehicles.
Most likely you will also need a high low adapter so that the tow bar will be level when you are flat towing. I attached a link to a page that has all of the ones we carry.
I have included a couple of helpful links to our articles on flat towing for you. Be sure to consult the vehicle owners manual for more specific information on flat towing your vehicle.

Products Referenced in This Question
Blue Ox 7-Wire to 6-Wire, Coiled Electrical Cord
- Accessories and Parts
- Flat Tow Wiring Harness
- Adapters
- 7 Round - Blade to 6 Round
- Coiled Cord
- Blue Ox
more information >
Roadmaster Universal Hy-Power Diode Wiring Kit
- Flat Tow Wiring Harness
- Splices into Vehicle Wiring
- Diode Kit
- Universal
- Tail Light Mount
- Roadmaster
more information >
Roadmaster Falcon 2 Tow Bar - RV Mount - 2" Hitch - 6,000 lbs
- Tow Bar
- Hitch Mount
- Telescoping - Binding
- Steel
- 6000 lbs
- Fits Roadmaster Base Plates - Crossbar
- Fits Roadmaster Base Plates - Direct Connect
- Stores on RV
- Cables Not Included
- Roadmaster
more information >
Roadmaster Direct-Connect Base Plate Kit - Removable Arms
- Tow Bar Base Plate
- Removable Draw Bars
- Twist Lock Attachment
- Partially Hidden
- Roadmaster
more information >
RoadMaster 68" Single Hook, Coiled Safety Cables - 6,000 lbs
- Safety Cables
- Coiled Cables
- 68 Inch Long
- 6000 lbs GTW
- Snap Hooks
- Coated Cables
- Roadmaster
more information >
Product Page this Question was Asked From
Roadmaster 4-Diode Universal Wiring Kit for Towed Vehicles - 4-Way Flat Connectors
- Flat Tow Wiring Harness
- Splices into Vehicle Wiring
- Diode Kit
- Universal
- Tail Light Mount
- Roadmaster
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Video: The Low-Down on the Blue Ox 7-Wire to 6-Wire, Coiled Electrical Cord
- Video: Complete Breakdown of the Hopkins Heavy-Duty, Coiled Trailer Connector Adapter
- Video: Review of the Safety Step Sand Away Dirt Trapping Step Cover
- Shop: Camco Premium RV Drinking Water Hose - 5/8" Inner Diameter - 10' Long
- Shop: Viair Portable Air Compressor - 150 psi - 1.80 CFM - Automatic
- Shop: Bargman 7-Way, RV-Style Connector w/ 6' Long Coiled Cable - Trailer End
- Shop: Curt Trailer Connector Adapter - 7-Way RV Style to 5-Way Flat - 60" Cord
- Shop: Hopkins Heavy-Duty, Coiled Trailer Connector Adapter - 7-Way to 6-Pole Round - Center Pin Brake
- Shop: Camco RV Drinking Water Hose - 1/2" Inner Diameter - 4' Long
- Shop: Blue Ox 7-Wire to 6-Wire, Coiled Electrical Cord
- Shop: Trailer Hitch
- Search Results: wentzville mo
- Search Results: rm~766
- Q&A: Parts Needed to Flat Tow a 2015 Ford Edge Titanium with 3.5 Liter Motor Behind a Motor Home
- Search Results: k23~463~00
- Video: DIY Install: Blue Ox Base Plate Kit on your 2018 Ford Edge
- Article: We Used 34 RV Tow Bars, and These are the Best for Flat Towing
- Video: SoftStartRV RV AC Unit Soft Start Install - Fifth Wheel
- Q&A: Taller Garnish Recommendation for Camco Roof Vent part # CAM40480
- Q&A: LCI Leveling System Troubleshooting
- Shop: Trailer Wiring
- Shop: Towing Mirrors
- Video: Best 2015 Ford Edge Base Plate Options
- Video: How to Set Up Your Roadmaster Direct-Connect Base Plate Kit on a 2017 Ford Edge
- Search Results: fireplace
- Search Results: 008~407~05
- Q&A: Flat Towing Components And Requirements For A 2024 Chevy Equinox
- Search Results: brake control harness
- Shop: Brake Controller
- Search Results: 92~03~9205
Richard B.
2/8/2020
Stan I hope you got my question about towing a 2015 sel ford edge flat tow can it be towed And what are the instructions you put in natural and do you leave the key on or what Thank You