Search: Trailer Bump Stop   >   !Trailer Coupler   >  

According to SumoSprings, 6" is the minimum for the #TSS-106-40. I asked them about this and they said you cannot use these if the space is under 6" so unfortunately they won't work for you. Doing so will overload the…

All of our bumper strips are 96" long and have the holes pre-drilled out at 11" on center, but the nice thing is these can be cut and re-drilled to accommodate your application. You just need to choose which one has the width…

What is the length of your leaf springs? Typically you put the hangers about 1/4 of an inch narrower than the length of the leaf springs from eye to eye when they are unloaded.

Based on what you are saying and your photos, it apprears you have springs that are double eye springs. The springs will need to be based on the load of your trailer. The axle capacity may be difficult to know as you said it appears to be custom. I…

In order for your trailer suspension to function properly you will want the angle of the shackle strap to be towards the axle so that as the leaf spring compresses and expands it will have somewhere it can go. Otherwise, you will not get the…

I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the 35" wheel base #MR27ZR will be the correct one for you, but…

You want leaf spring shackles to be at a slight angle as that prevents the springs from flipping around to the other side of the equalizer over uneven terrain. I attached a picture that shows what the angle is typically like.

Yes, when replacing sewer parts that have been installed with ABS Solvent Cement like part #A05-0303 you will need to cut the pipe right where the old valve is installed so you can install the Valterra Waste Valves #TR38. If you think this will…

The pilot diameter on a wheel, like the one with part #AM30620, is the diameter of the bigger hole that is directly in the middle of the wheel. The pilot hole diameter of the wheel for the part I just measured is 2.84". I have attached a…

The importance of matching a wheel's pilot hole diameter to the part of the hub that fits through it depends on the type of wheel. A hub-centric wheel uses the pilot hole to center the wheel on the hub and also to bear some of the total…

I have a different option for you, but changing the axle tube diameter will not increase the axle capacity as the new weakest link would be the spindles which would still have a 3500lb capacity. You could start from scratch and use two of the #42…

It sounds like you are looking for the Dexstar Steel Mini Mod Trailer Wheel part #AM20436 which matches all the specs in the photo you attached. The manufacturers part number for this wheel is also 017-231.