2011 Can-Am Outlander Max 800 ATV Winch Mount

I believe you are asking how to remove the shower door part #PF267001 from the shower box without damaging the frame of the shower box. There should be a pin with a spring on either side of the door. If you can compress those pins in the door, you…

I went out into our warehouse to grab a Dutton Lainson Winch part #DL14627 to measure the bolt hole dimensions for you. I attached a picture that has all of them listed.

Yes, The Bulldog Winch Custom Winch Mount #BDW15148 will fit your 2002 Artic Cat 500i Automatic 4x4 with liquid cooling. It was designed for models with liquid cooling so it'll work fine with the radiator.

I have just what you will need. I have linked an FAQ article that explains the various ways to wire a winch. You will need the second half of the page titled Option 2: Wiring the Winch to a Separate, Trailer-Mounted Battery. I have also included a…

Winch mounting bracket #BDW15148 is designed to fit a 2002 Arctic Cat 500 Manual 4x4 or Automatic 4x4 and Automatic TBX 4x4. We only carry this one bracket for 2002 Arctic Cat 500 models.

If you're going to use a winch to raise and lower your popup you will want a winch that power loads both in and out. With a winch that will only power load in you will only be able to raise the popup and not lower with the winch. We have the…

Thanks for the picture of the trailer wiring connector you have. Based on that you are in need of a 7-way blade extension like the part #C56080 for a 7 foot long extension or part #HM20049 for an 8 foot long extension. Or if you are looking for…

For your 1997 Suzuki King Quad 300 the Bulldog Winch ATV mount part #BDW15135 that you referenced is a confirmed fit.

Hitch extenders like the etrailer part #e88YR reduce hitch capacity for two reasons. One is the length like you mentioned and the other is amount of additional movement that they introduce to the hitch setup which puts quite a bit of stress on the…

I wish we had an exact figure we could give you on that. But the general rule of thumb is that anytime you use a hitch extender you end up cutting the capacity of the hitch by 50 percent. This is due to the added leverage like you mentioned as well…

The Curt ATV Towing Starter Kit #C45038 is designed to work on any ATV that has a tongue area for mounting a hitch ball with a 3/4-inch hole diameter. The receiver portion with the tow strap loop uses an included 3/4-inch bolt to install in that…

I do have a solution for you, however, we not offer winch mounting plates specifically for Badlands Winches. Most winches use the industry-standard bolt pattern, but you will want to verify fitment with Badlands or drill your own mounting holes if…