Custom Fit 2020 Ford Ranger Accessories

The trailer hitch that I recommend for a 2020 Ford Ranger is the Curt Trailer Hitch Receiver part #C13417 which is a custom bolt-on fit that does not require any cutting or drilling. The process should actually only take you around 20 to 40 minutes.…

Assuming that when you tested the resistance of the brakes you were testing the two wires on each magnet and getting 2.0 and 2.8 ohms the magnets on your trailer are not working correctly and will need to be replaced. For 7" brakes you should…

Buongiorno! We do carry Replacement Magnet Kit for 7" Electric Trailer Brake Assemblies - 2,000 lbs Item #AKBRKR-M7. However, it looks like the center mounting hole on yours is round, whereas ours uses a square/rectangular hole. It doesn't…

If you are seeing a message that says trailer disconnected that would mean that the Echo #C51180 is not connected to the trailer at all and would not be able to control the brakes. If this is an intermittent issue then most likely it's just a bit…

The adapter you need to go from your Demcoo tow bar to your Blue Ox base plate kit is the part #DM9523041.

Yes, you will be able to connect a brake controller pretty easily to your 2021 Ford Ranger since it has the factory tow package. For the Ranger Ford decided to bundle up some wires up under the driver's side dash near the left-hand kick panel as…

Since the Torflex Lift Kit #K71-723-01 will put the frame of your trailer up 2-5/8" higher than what it is now you can go with a bigger tire size. The largest that I recommend going with is the ST185/80R13 for which we have the Kenda Karrier…

Yes, the HitchMate StabiLoad Support for Cargo Stabilizer Bars #HE4017 would fit over the end of a 2x4.

I had our warehouse measure each of the front mount trailer hitch receivers you mentioned, and the dimensions are as follows. The Curt #31408 measures 32-3/4" long x 8-3/4" wide, the Draw-Tite #65080 measures 36-3/4" long x…

I went out the warehouse and took the measurements you asked about on the Curt Front Mount Hitch, part #31408. I've attached a diagram showing them. The inside distance between the mounting plates is about 27-1/2 inches. Between the 2 sets of…

Hey William! I don't have a way of knowing how much space there is on a 2023 Gladiator without one here to test it. What I can tell you is that the #FR95DJ measures 2-5/8" long x 50" wide x 21-11/16" tall so you can use those…

The ball must be greased when using the Curt RockerBall Shock Absorbing 2" Hitch Ball #C40047. As you can see by the cut out of the linked instructions, if you don't have adequate lubrication the ball can fail so it is imperative you do. The…